Ocosta soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 20 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ocosta soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ocosta silty clay loam (Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 53% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (45): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil very sticky and very plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 40 in (101 cm)).
- Note Typically starts within about 20 in (51 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Clay-rich layerH1 A silty clay loam layer about 0 to 12 in down: about 35% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay-rich layerH2 A silty clay layer about 12 to 20 in down: about 53% clay, high plasticity when wet, dark grayish brown when moist. Strong lead
- Clay-rich layerH3best layer A clay layer about 20 to 60 in down: about 53% clay, high plasticity when wet, very dark grayish brown when moist. Strong lead
What it looks like raw
The clay-rich layer (H3), 20 to 60 in down in the typical profile: very dark grayish brown (2.5Y 3/2); very hard, very firm, very sticky and very plastic. Raw colour is not fired colour.
About the soil
- Parent material: clayey alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Coastal areas of western Washington. This soil is of moderate extent.
USDA, geographic setting: The Ocosta soils are on flat or depressed areas and are subject to tidal overflow during storms and high tides unless protected by dikes. The soils formed in clayey alluvium deposited in the quiet water of coastal bays. These soils occur in a coastal marine climate with relatively cool summers and mild wet winters. They have an annual precipitation of 70 to 100 inches. The average January temperature is 39 degrees F.; the average July temperature is 62 degrees F.; and the mean annual temperature is 50 degrees F. The growing season (28 degrees F.) is 180 to 250 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Vesta: Promising
- Ilwaco: Possible
- Knappton: Possible
- Narel: Possible
- Nuby: Possible
- Montesa: Weak indication
- Bellingham: Strong lead(same state)
- Cloverland: Strong lead(same state)
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ocosta silty clay loam, map unit 104 in Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
- Official Series Description: Ocosta(revised 06/2005), established.
- Taxonomic class: Fine, mixed, superactive, acid, isomesic Sulfic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.