Knappton soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 12 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Knappton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Knappton spot on the map
Rated from the USDA soil survey record for Knappton silt loam, 8 to 30 percent slopes (Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12.5).
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 31 in (79 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 26% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A silt loam layer about 0 to 12 in down: about 15% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Loamy layerH2best layer A gravelly silty clay loam layer about 12 to 43 in down: about 28% clay, moderate plasticity when wet, strong brown when moist. Possible
- BedrockH3 Weathered bedrock about 43 to 47 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 12 to 43 in down in the typical profile: strong brown (7.5YR 5/6), reddish yellow (7.5YR 6/6) dry; slightly hard, friable, moderately sticky and moderately plastic and weakly smeary. Raw colour is not fired colour.
About the soil
- Parent material: colluvium derived from basalt.
- USDA family particle-size class: medial.
- Drainage: well drained.
- Paralithic bedrock typically about 43 in (109 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Within 15 miles of the Pacific Coast in southwestern Washington. The series is moderately extensive.
USDA, geographic setting: Knappton soils are on narrow ridgetops and colluvial side slopes in mountainous uplands. Slopes are 1 to 90 percent. These soils formed in material from highly weathered basalt colluvium. Elevations range from 100 to 1,800 feet. The climate is marine with cool wet winters and cool dry summers. The mean precipitation ranges from 80 to 170 inches. The mean January temperature is 38 degrees F., mean July temperature is 60 degrees F., and the mean annual temperature is 48 degrees F. and ranges from 46 degrees to 51 degrees F. The frost free period is 140 to 220 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ocosta: Strong lead
- Vesta: Promising
- Ilwaco: Possible
- Narel: Possible
- Nuby: Possible
- Montesa: Weak indication
- Bellingham: Strong lead(same state)
- Cloverland: Strong lead(same state)
See it on the map
Open a Knappton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Knappton silt loam, 8 to 30 percent slopes, map unit 59 in Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
- Official Series Description: Knappton(revised 01/2000), established.
- Taxonomic class: Medial, ferrihydritic, isomesic Typic Fulvudands
- Rated with rule version 2026-09-28.1; the method is on the About page.