Ilwaco soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 17 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ilwaco soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Ilwaco silt loam, 8 to 30 percent slopes (Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (12.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 43 in (109 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Sandy layerH1 A medial silt loam layer about 0 to 17 in down: about 15% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerH2best layer A medial silt loam layer about 17 to 60 in down: about 20% clay, moderate plasticity when wet, dark yellowish brown when moist. Possible
What it looks like raw
The loamy layer (H2), 17 to 60 in down in the typical profile: dark yellowish brown (10YR 4/6), brownish yellow (10YR 6/6) dry; slightly hard, friable, slightly sticky, slightly plastic and weakly smeary. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone.
- USDA family particle-size class: medial.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Southwestern Washington; MLRA 4A. The series is of small extent.
USDA, geographic setting: Ilwaco soils are on uplands at elevations from sea level to 1,200 feet. These soils occupy broad ridgetops, small plateaus, and back and shoulder slopes. Slopes are 1 to 75 percent. The soils formed in material from deeply weathered siltstone, sandstone and conglomerate. The marine climate is characterized by cool, wet winters, and cool, dry summers. The mean annual precipitation is 80 to 120 inches. The mean January temperature is 38 degrees F.; mean July temperature is 60 degrees F.; and the mean annual temperature is 48 degrees F. The frost-free period is 160 to 220 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ocosta: Strong lead
- Vesta: Promising
- Knappton: Possible
- Narel: Possible
- Nuby: Possible
- Montesa: Weak indication
- Bellingham: Strong lead(same state)
- Cloverland: Strong lead(same state)
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ilwaco silt loam, 8 to 30 percent slopes, map unit 50 in Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
- Official Series Description: Ilwaco(revised 02/2011), established.
- Taxonomic class: Medial, ferrihydritic, isomesic Typic Fulvudands
- Rated with rule version 2026-09-28.1; the method is on the About page.