Montesa soil
Wild-clay potential
Weak indication
Weak indication: no layer of Montesa shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Montesa soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Montesa spot on the map
Rated from the USDA soil survey record for Montesa silt loam, 1 to 8 percent slopes (Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (2.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil nonsticky and slightly plastic.
- Note Thick enough to investigate (about 35 in (88 cm)).
- Note Typically starts about 25 in (64 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Sandy layerH1 A medial silt loam layer about 0 to 18 in down: about 13% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A fine sandy loam layer about 18 to 25 in down: about 13% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerH3best layer A silt loam layer about 25 to 60 in down: about 13% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 25 to 60 in down in the typical profile: pale brown (10YR 6/3), very pale brown (10YR 7/3) dry, dark yellowish brown (10YR 4/4) rubbed, light brownish gray (10YR 6/2) rubbed; slightly hard, very friable, nonsticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Southwestern Washington and possibly northwestern Oregon. The series is of small extent.
USDA, geographic setting: Montesa soils are on alluvial fans and stream terraces at elevations ranging from 25 to 300 feet. Slopes are 1 to 8 percent. These soils formed in alluvium weathered from igneous and sedimentary rocks from adjacent uplands and mountainous areas. They occur in a humid marine climate with cool, wet winters and cool, dry summers. The annual precipitation ranges from 70 to 110 inches. The mean January temperature is 39 degrees F.; the mean July temperature is 60 degrees F.; and the mean annual temperature is 50 degrees F. The growing season (28 degrees F.) is 200 to 240 days or (32 degrees F.) 160 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ocosta: Strong lead
- Vesta: Promising
- Ilwaco: Possible
- Knappton: Possible
- Narel: Possible
- Nuby: Possible
- Bellingham: Strong lead(same state)
- Cloverland: Strong lead(same state)
See it on the map
Open a Montesa spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Montesa silt loam, 1 to 8 percent slopes, map unit 79 in Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
- Official Series Description: Montesa(revised 09/1999), established.
- Taxonomic class: Coarse-loamy, isotic, mesic Aquandic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.