Nuby soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 7 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nuby soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Nuby silt loam (Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 53 in (134 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Missing data Rock fragment content is not reported.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 7 in down: about 23% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2best layer A silt loam layer about 7 to 60 in down: about 27% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
What it looks like raw
The loamy layer (H2), 7 to 60 in down in the typical profile: dark grayish brown (10YR 4/2), light gray (10YR 7/2) dry; slightly hard, friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Washington, in these survey areas: Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Coastal floodplains of western Washington; MLRA 4A. The series is of small extent.
USDA, geographic setting: These soils are nearly level floodplains usually subject to stream overflow. Elevation ranges from 10 to 100 feet. The soils formed in medium and moderately fine textured alluvial deposits derived from basic igneous and sedimentary rocks. These soils occur in cool, coastal areas where the mean annual precipitation is 70 to 120 inches. The mean January temperature is 39 degrees F.; the mean July temperature is 60 degrees F.; and the mean annual temperature is about 50 degrees F. The frost free season is 160 and 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Ocosta: Strong lead
- Vesta: Promising
- Ilwaco: Possible
- Knappton: Possible
- Narel: Possible
- Montesa: Weak indication
- Bellingham: Strong lead(same state)
- Cloverland: Strong lead(same state)
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nuby silt loam, map unit 102 in Grays Harbor County Area, Pacific and Wahkiakum Counties, Washington.
- Official Series Description: Nuby(revised 02/2011), established.
- Taxonomic class: Fine-silty, mixed, superactive, acid, isomesic Fluvaquentic Endoaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.