Nolin soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 8 to 52 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nolin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Nolin silt loam, local alluvium, 0 to 5 percent slopes (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 27% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (14).
- Note Thick enough to investigate (about 44 in (112 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 8 in down: about 24% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH2best layer A silt loam layer about 8 to 52 in down: about 27% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH3 A silty clay loam layer about 52 to 65 in down: about 30% clay, moderate plasticity when wet, brown when moist. Possible
What it looks like raw
The loamy layer (H2), 8 to 52 in down in the typical profile: brown (10YR 4/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from sedimentary rock over residuum weathered from limestone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Pennsylvania, in these survey areas: Centre County, Pennsylvania; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: In areas of mixed limestones and siltstones, sandstones, shales, and loess in Kentucky, Illinois, Indiana, Maryland, Ohio, Pennsylvania, Tennessee, West Virginia and Virginia. The series is of large extent.
USDA, geographic setting: The Nolin soils are on nearly level flood plains, in concave depressions, or on natural levees of major rivers and streams. The soils formed in alluvium derived from limestone, sandstone, siltstone, shale, and loess. Near the type location the mean annual temperature is 48 to 57 degrees F., and the mean annual precipitation is 38 to 50 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Dunning: Strong lead
- Hublersburg: Strong lead
- Millheim: Strong lead
- Opequon: Strong lead
- Lindside: Promising
- Bowmansville: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nolin silt loam, local alluvium, 0 to 5 percent slopes, map unit No in Centre County, Pennsylvania.
- Official Series Description: Nolin(revised 02/2009), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Dystric Fluventic Eutrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.