Nihill soil
Wild-clay potential
Weak indication
Weak indication: no layer of Nihill shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Nihill soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Nihill-Attewan complex, 4 to 20 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 17% clay.
- Note Moderate engineering plasticity index (10).
- Lowers the potential The official series description calls the wet soil slightly sticky and nonplastic.
- Note Thick enough to investigate (about 56 in (142 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Lowers the potential High rock content (about 46% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A gravelly loam layer about 0 to 4 in down: about 19% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2best layer A very gravelly sandy loam layer about 4 to 60 in down: about 17% clay, moderate plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 4 to 60 in down in the typical profile: very pale brown (10YR 7/3), light yellowish brown (10YR 6/4) moist; slightly hard, friable, slightly sticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: North central and eastern Wyoming, South Dakota, and Colorado. The series is extensive.
USDA, geographic setting: Nihill soils are on late Pleistocene terraces and terrace remnants. They formed in calcareous gravelly alluvium from mixed sources. Slopes are 0 to 80 percent. Elevations range from 2,600 to 6,800 feet. The mean annual precipitation is about 16 inches but ranges from 10 to 19 inches with about half falling as snow or rain in April, May, and early June. The mean annual temperature is about 46 degrees F., but ranges from 44 to 50 degrees F. The frost-free season is estimated to range from 105 to 130 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Nihill-Attewan complex, 4 to 20 percent slopes, map unit NaD in Meade County, South Dakota, Northern Part.
- Official Series Description: Nihill, established.
- Taxonomic class: Loamy-skeletal, mixed, superactive, calcareous, mesic Ustic Torriorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.