Neshaminy soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 17 to 32 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Neshaminy soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Neshaminy spot on the map
Rated from the USDA soil survey record for Neshaminy silt loam, 0 to 3 percent slopes (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt1" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (18).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Note Few rock fragments (about 9% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 6 in down: about 18% clay, moderate plasticity when wet, very dark grayish brown when moist. Weak indication
- Loamy layerBE A silt loam layer about 6 to 17 in down: about 19% clay, moderate plasticity when wet, strong brown when moist. Possible
- Clay subsoilBt1best layer A silt loam layer about 17 to 32 in down: about 25% clay, moderate plasticity when wet, yellowish red when moist. Possible
- Clay subsoilBt2 A channery silt loam layer about 32 to 59 in down: about 21% clay, high plasticity when wet, yellowish red when moist. Weak indication
- Loamy layerBC A very channery loam layer about 59 to 80 in down: about 21% clay, moderate plasticity when wet, yellowish red when moist. Weak indication
What it looks like raw
The clay subsoil (Bt1), 17 to 32 in down in the typical profile: yellowish red (5YR 4/6); channery clay loam; friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from gabbro.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 98 in (250 cm) down.
Where it is mapped
Seen on the map as the most common soil in 78 map units in Delaware, Maryland, Pennsylvania, in these survey areas: Baltimore County, Maryland; Berks County, Pennsylvania; Bucks County, Pennsylvania; Chester County, Pennsylvania; Delaware County, Pennsylvania; Harford County Area, Maryland; Lancaster County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Montgomery County, Pennsylvania; and 2 more.
By state: wild clay in Delaware,wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania, Maryland, Delaware, and New Jersey. Neshaminy soils are extensive, totaling more than 150,000 acres.
USDA, geographic setting: Neshaminy soils are nearly level to very steep slopes on uplands.. They have developed in materials weathered from diabase and other dark colored basic rocks. The climate is temperate and humid; mean annual air temperature ranges from 45 to 55 degrees F., mean annual precipitation ranges from 38 to 46 inches, and the frost-free season ranges from 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Hagerstown: Strong lead
- Christiana: Strong lead
- Talleyville: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
See it on the map
Open a Neshaminy spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Neshaminy silt loam, 0 to 3 percent slopes, map unit NeA in Harford County Area, Maryland.
- Official Series Description: Neshaminy(revised 10/2008), established.
- Taxonomic class: Fine-loamy, mixed, superactive, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.