Neilton soil
Wild-clay potential
Weak indication
Weak indication: no layer of Neilton shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Neilton soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Neilton spot on the map
Rated from the USDA soil survey record for Neilton gravelly loamy sand, 0 to 3 percent slopes (Kitsap County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 41 in (104 cm)).
- Note Typically starts within about 19 in (48 cm) of the surface.
- Lowers the potential High rock content (about 47% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly loamy sand layer about 0 to 4 in down: about 3% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2 A very gravelly loamy sand layer about 4 to 19 in down: about 3% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerH3best layer A very gravelly sand layer about 19 to 60 in down: about 3% clay, low plasticity when wet, dark grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 19 to 60 in down in the typical profile: dark grayish brown (2.5Y 4/2), light brownish gray (2.5Y 6/2) dry; loose. Raw colour is not fired colour.
About the soil
- Parent material: gravelly and sandy outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Kitsap County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington. The series is of moderate extent.
USDA, geographic setting: Neilton soils are on glacial outwash terraces and terrace escarpments. Slopes range from 0 to 70 percent. The soils formed in glacial outwash materials derived from granite, quartzite, shale, sandstone, schist, basalt, and andesite. Neilton soils are at elevations ranging from sea level to 1,600 feet. They have a mild climate with an average annual precipitation of 30 to 60 inches; cool, dry summers and mild, wet winters. The average January temperature is 36 degrees F.; the average July temperature is 63 degrees F.; and the mean annual temperature is about 50 degrees F. The frost free season ranges from 140 to 220 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bellingham: Strong lead
- McKenna: Promising
- Shalcar: Promising
- Kitsap: Possible
- Alderwood: Weak indication
- Belfast: Weak indication
- Harstine: Weak indication
- Indianola: Weak indication
See it on the map
Open a Neilton spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Neilton gravelly loamy sand, 0 to 3 percent slopes, map unit 34 in Kitsap County Area, Washington.
- Official Series Description: Neilton(revised 04/2000), established.
- Taxonomic class: Sandy-skeletal, mixed, mesic Dystric Xerorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.