Indianola soil
Wild-clay potential
Weak indication
Weak indication: no layer of Indianola shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Indianola soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Indianola spot on the map
Rated from the USDA soil survey record for Indianola loamy sand, 5 to 15 percent slopes (Jefferson County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 37 in (94 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA A loamy sand layer about 1 to 6 in down: about 4% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerBw1 A loamy sand layer about 6 to 17 in down: about 2% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw2 A sand layer about 17 to 27 in down: about 2% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBC A sand layer about 27 to 37 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerCbest layer A sand layer about 37 to 60 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 37 to 60 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; loose, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: sandy glacial outwash.
- USDA family particle-size class: not used.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 8 map units in Washington, in these survey areas: Jefferson County Area, Washington; Kitsap County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Puget lowlands in Northwestern Washington, MLRA 2, northern part. The series is of moderate extent.
USDA, geographic setting: Indianola soils are on hills, terraces, terrace escarpments, eskers, or kames of drift or outwash plains at elevations of near sea level to 1,000 feet. Slopes are 0 to 70 percent. These soils formed in sandy glacial drift and minor amounts of volcanic ash. They are in a maritime climate of cool dry summers and mild wet winters. Mean annual precipitation ranges from 30 to 55 inches most of which falls between October and April. Mean January temperature is 36 degrees F., the average July temperature is 62 degrees F., and mean annual temperature is 50 degrees F. The frost-free season ranges from 180 to 240 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bellingham: Strong lead
- Quilcene: Strong lead
- McKenna: Promising
- Shalcar: Promising
- Wapato: Promising
- Kitsap: Possible
- Lummi: Possible
- Alderwood: Weak indication
See it on the map
Open a Indianola spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Indianola loamy sand, 5 to 15 percent slopes, map unit InC in Jefferson County Area, Washington.
- Official Series Description: Indianola(revised 07/2009), established.
- Taxonomic class: Isotic, mesic Dystric Xeropsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.