Harstine soil
Wild-clay potential
Weak indication
Weak indication: no layer of Harstine shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Harstine soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Harstine spot on the map
Rated from the USDA soil survey record for Harstine gravelly ashy sandy loam, 0 to 6 percent slopes (Kitsap County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 23 in (58 cm)).
- Note Typically starts about 38 in (97 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 0 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- Sandy layerBw1 A gravelly ashy sandy loam layer about 1 to 6 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBw2 A gravelly ashy sandy loam layer about 6 to 14 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBw3 A gravelly ashy sandy loam layer about 14 to 22 in down: about 8% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerBw4 A gravelly ashy sandy loam layer about 22 to 32 in down: about 8% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layer2Cd1 A gravelly loamy sand layer about 32 to 38 in down: about 5% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layer2Cd2best layer A gravelly loamy sand layer about 38 to 61 in down: about 5% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (2Cd2), 38 to 61 in down in the typical profile: grayish brown (2.5Y 5/2) dry, light brownish gray (10YR 6/2) dry; very firm, hard. Raw colour is not fired colour.
About the soil
- Parent material: sandy glacial drift with an influence of volcanic ash over dense glaciomarine deposits.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Washington, in these survey areas: Kitsap County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Northwestern Washington; MLRA 2; moderate extent
USDA, geographic setting: Elevation--sea level to 120 m
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bellingham: Strong lead
- McKenna: Promising
- Shalcar: Promising
- Kitsap: Possible
- Alderwood: Weak indication
- Belfast: Weak indication
- Indianola: Weak indication
- Kapowsin: Weak indication
See it on the map
Open a Harstine spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Harstine gravelly ashy sandy loam, 0 to 6 percent slopes, map unit 14 in Kitsap County Area, Washington.
- Official Series Description: Harstine(revised 11/2017), established.
- Taxonomic class: Coarse-loamy, isotic, mesic Vitrandic Dystroxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.