Kapowsin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kapowsin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kapowsin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Kapowsin spot on the map
Rated from the USDA soil survey record for Kapowsin gravelly ashy loam, 0 to 6 percent slopes (Kitsap County Area, Washington) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 10% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil moderately sticky and slightly plastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 29 in (74 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 20% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A gravelly ashy loam layer about 0 to 7 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBhs A gravelly ashy loam layer about 7 to 11 in down: about 10% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerBs1 A gravelly ashy loam layer about 11 to 15 in down: about 10% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layer2Bs2 A loam layer about 15 to 25 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Clay subsoil3Bstm A loam layer about 25 to 29 in down: about 10% clay, low plasticity when wet, olive brown when moist. Weak indication
- Sandy layer3Cdbest layer A gravelly loam layer about 29 to 59 in down: about 10% clay, low plasticity when wet, grayish brown when moist. Weak indication
What it looks like raw
The sandy layer (3Cd), 29 to 59 in down in the typical profile: grayish brown (2.5Y 5/2), light brownish gray (2.5Y 6/2) dry; hard, firm, moderately sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash mixed with glacial drift over dense glaciomarine deposits.
- USDA family particle-size class: coarse-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Washington, in these survey areas: Kitsap County Area, Washington.
By state: wild clay in Washington.
USDA, distribution and extent: Puget lowlands in west central Washington. The series is of small extent.
USDA, geographic setting: Kapowsin soils are on convex or undulating glacial till plains and moraines at elevations from 15 to 275 meters. Slopes are 0 to 70 percent. These soils formed in glacial drift with an influence of ash over dense glaciomarine deposits. They occur in a mild marine climate having an average annual precipitation ranging from 762 to 1270 mm. Mean January temperature is 4 degrees C; mean July temperature is 14 degrees C; and mean annual temperature is 10 degrees C. The summers are cool and dry. Winters are mild and wet with most of the annual precipitation occurring as rain from November through March. The frost-free season is about 150 to 220 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Bellingham: Strong lead
- McKenna: Promising
- Shalcar: Promising
- Kitsap: Possible
- Alderwood: Weak indication
- Belfast: Weak indication
- Harstine: Weak indication
- Indianola: Weak indication
See it on the map
Open a Kapowsin spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kapowsin gravelly ashy loam, 0 to 6 percent slopes, map unit 22 in Kitsap County Area, Washington.
- Official Series Description: Kapowsin(revised 10/2014), established.
- Taxonomic class: Coarse-Loamy, isotic, mesic Andic Dystroxerepts
- Rated with rule version 2026-09-28.1; the method is on the About page.