Morris soil
Wild-clay potential
Weak indication
Weak indication: no layer of Morris shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Morris soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Morris flaggy silt loam, 0 to 3 percent slopes (Delaware County, New York) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 16% clay.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 44 in (111 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 25% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A flaggy silt loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet. Weak indication
- Sandy layerBw A channery silt loam layer about 8 to 12 in down: about 16% clay, moderate plasticity when wet. Weak indication
- Sandy layerEg A channery silt loam layer about 12 to 16 in down: about 14% clay, moderate plasticity when wet. Weak indication
- Sandy layerBxbest layer A channery silt loam layer about 16 to 60 in down: about 16% clay, moderate plasticity when wet. Weak indication
- Sandy layerC A flaggy loam layer about 60 to 72 in down: about 14% clay, moderate plasticity when wet. Weak indication
What it looks like raw
The sandy layer (Bx), 16 to 60 in down in the typical profile: firm, slightly sticky and slightly plastic; brittle. Raw colour is not fired colour.
About the soil
- Parent material: loamy till from reddish sandstone, siltstone, and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 6 map units in New York, in these survey areas: Delaware County, New York; Schoharie County, New York.
By state: wild clay in New York.
USDA, distribution and extent: Southern New York and north central and northeastern Pennsylvania. Almost all of the acreage occurs in MLRA 140. The remainder of the acreage occurs in transitional areas along the boundary of MLRA 140 in MLRAs 127, 147 and 144A. The series is of large extent.
USDA, geographic setting: Morris soils are in till plains and slightly concave uplands. Slopes are dominantly 2 to 15 percent but range from about 0 to 25. The soils formed in firm glacial till derived from reddish sandstone, siltstone and shale. Mean annual precipitation ranges from 795 to 1725 mm (31 to 68 inches), but can range as high as 1790mm (70 inches) in higher elevations. Mean annual temperature ranges from 6 to 11 degrees C (43 to 52 degrees F), but in some higher elevations it can range as low as 4 degrees C (39 degrees F). The frost-free season ranges from 105 to 180 days. These soils generally occur at elevation between 100 to 670 meters (328 to 2,198 feet) above sea level, but have been mapped as...
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lakemont: Strong lead
- Phelps: Strong lead
- Holly: Promising
- Barbour: Weak indication
- Basher: Weak indication
- Bath: Weak indication
- Lackawanna: Weak indication
- Lordstown: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Morris flaggy silt loam, 0 to 3 percent slopes, map unit MrA in Delaware County, New York.
- Official Series Description: Morris(revised 01/2015), established.
- Taxonomic class: Coarse-loamy, mixed, active, mesic Aeric Fragiaquepts
- Rated with rule version 2026-09-28.1; the method is on the About page.