Meckesville soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 7 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Meckesville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Meckesville spot on the map
Rated from the USDA soil survey record for Meckesville silt loam, 3 to 8 percent slopes (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (8.5).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts within about 7 in (18 cm) of the surface.
- Note Few rock fragments (about 13% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 7 in down: about 19% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerH2best layer A silt loam layer about 7 to 31 in down: about 20% clay, moderate plasticity when wet, reddish brown when moist. Possible
- Loamy layerH3 A channery silt loam layer about 31 to 70 in down: about 20% clay, low plasticity when wet, weak red when moist. Weak indication
- Loamy layerH4 A very channery silt loam layer about 70 to 96 in down: about 20% clay, low plasticity when wet, weak red when moist. Weak indication
What it looks like raw
The loamy layer (H2), 7 to 31 in down in the typical profile: reddish brown (2.5YR 4/4); friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: sandstone, siltstone and shale colluvium derived from sedimentary rock.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 85 in (217 cm) down.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Centre County, Pennsylvania; Huntingdon County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, Maryland, West Virginia, and possibly Virginia. The series is of moderate extent. MLRA's 125, 127, 128, 130, 140, 145, 147, 148.
USDA, geographic setting: Meckesville soils are nearly level to steep soils on middle and lower slopes of dissected uplands. Slopes range from 0 to 35 percent. The soils formed in colluvium, glacial till or congeliturbate from red acid sandstone, siltstone, and shale. Climate is humid and temperate, with mean annual precipitation of 34 to 48 inches; average annual temperature is 45 degrees to 55 degrees F., and the growing season is 130 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hublersburg: Strong lead
- Opequon: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Hagerstown: Strong lead
- Millheim: Strong lead
- Purdy: Strong lead
- Shelmadine: Promising
See it on the map
Open a Meckesville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Meckesville silt loam, 3 to 8 percent slopes, map unit MeB in Centre County, Pennsylvania.
- Official Series Description: Meckesville(revised 11/2021), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.