Markes soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 0 to 7 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Markes soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Markes silt loam, 0 to 5 percent slopes (Lebanon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Moderate thickness (about 7 in (18 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- Loamy layerH1best layer A silt loam layer about 0 to 7 in down: about 23% clay, moderate plasticity when wet, dark grayish brown when moist. Possible
- Loamy layerH2 A very channery silty clay loam layer about 7 to 15 in down: about 28% clay, moderate plasticity when wet, light olive gray when moist. Weak indication
- Loamy layerH3 A very channery silty clay loam layer about 15 to 31 in down: about 28% clay, moderate plasticity when wet, light olive gray when moist. Weak indication
- BedrockH4 Bedrock about 31 to 35 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H1), 0 to 7 in down in the typical profile: dark grayish brown (2.5Y 4/2); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: poorly drained.
- Lithic bedrock typically about 31 in (79 cm) down.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Pennsylvania, in these survey areas: Lebanon County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania and Maryland. The series is of moderate extent. Pennsylvania has an estimated 15,000 acres.
USDA, geographic setting: These soils are nearly level to sloping uplands with slope gradients ranging from 0 to 15 percent. The soils developed in materials weathered largely from gray shale. The climate is humid temperate with mean annual precipitation of 36 to 46 inches, mean annual air temperatures of 50 to 55 degrees F., and a frost free season of 150 to 190 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Bowmansville: Promising
- Brinkerton: Promising
- Bucks: Promising
- Chester: Promising
- Comly: Promising
- Duffield: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Markes silt loam, 0 to 5 percent slopes, map unit MaA in Lebanon County, Pennsylvania.
- Official Series Description: Markes(revised 12/2005), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Typic Endoaqualfs
- Rated with rule version 2026-09-28.1; the method is on the About page.