Lohmiller soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 23 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lohmiller soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lohmiller spot on the map
Rated from the USDA soil survey record for Lohmiller silty clay loam (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 43% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22.5): USDA's estimate suggests plastic behavior when wet.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 23 in (58 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Clay-rich layerH1 A silty clay loam layer about 0 to 4 in down: about 38% clay, moderate plasticity when wet, grayish brown when moist. Promising
- Clay-rich layerH2 A clay loam layer about 4 to 23 in down: about 39% clay, high plasticity when wet, grayish brown when moist. Strong lead
- Clay-rich layerH3best layer A stratified fine sandy loam to clay layer about 23 to 60 in down: about 43% clay, high plasticity when wet, grayish brown when moist. Strong lead
What it looks like raw
The clay-rich layer (H3), 23 to 60 in down in the typical profile: grayish brown (2.5Y 5/2); very hard, firm. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Western South Dakota, northeastern Colorado, and eastern Wyoming. It is of large extent.
USDA, geographic setting: Lohmiller soils are on flood plains and high bottom lands of rivers and streams and on alluvial fans of foot slopes. Slopes are typically less than 2 percent but range from 0 to 8 percent. The soils formed in calcareous alluvium from sedimentary rock. Mean annual air temperature ranges from 45 to 48 degrees F, and mean annual precipitation ranges from 10 to 19 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Open a Lohmiller spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lohmiller silty clay loam, map unit Ld in Meade County, South Dakota, Northern Part.
- Official Series Description: Lohmiller(revised 11/2005), established.
- Taxonomic class: Fine, smectitic, calcareous, mesic Torrertic Ustifluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.