Lewiston soil
Wild-clay potential
Weak indication
Weak indication: no layer of Lewiston shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Lewiston soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Lewiston spot on the map
Rated from the USDA soil survey record for Lewiston loam, 0 to 1 percent slopes (Salt Lake Area, Utah) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 38 in (97 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 3% by volume).
- Note USDA reports about 8% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- TopsoilAp A loam layer about 0 to 7 in down: about 16% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- TopsoilA1&AC A very fine sandy loam layer about 7 to 20 in down: about 15% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerC1ca A silt loam layer about 20 to 26 in down: about 16% clay, moderate plasticity when wet, light gray when moist. Weak indication
- TopsoilA1b A very fine sandy loam layer about 26 to 31 in down: about 15% clay, moderate plasticity when wet, light gray when moist. Weak indication
- Sandy layerIIC2 A silt loam layer about 31 to 38 in down: about 16% clay, moderate plasticity when wet, pinkish gray when moist. Weak indication
- Sandy layerIIIC3-5best layer A loamy sand layer about 38 to 68 in down: about 5% clay, low plasticity when wet, pinkish gray when moist. Weak indication
What it looks like raw
The sandy layer (IIIC3-5), 38 to 68 in down in the typical profile: pinkish gray (7.5YR 7/2), pinkish gray (7.5YR 6/2) moist; slightly hard, very friable, nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Utah, in these survey areas: Davis-Weber Area, Utah; Salt Lake Area, Utah.
By state: wild clay in Utah.
USDA, distribution and extent: Northern Utah and southern Idaho. These soils are not extensive. MLRAs 13 and 28A.
USDA, geographic setting: Lewiston soils are at elevations of 4,430 to 4,500 feet above sea level on nearly level to gently sloping low lake terraces with slopes of 0 to 3 percent. They formed in moderately coarse, mixed lake sediments. The climate is dry subhumid, mean annual temperature is 45 degrees to 48 degrees F., the mean summer temperature is 68 degrees to 72 degrees F., and the average annual precipitation is 13 to 17 inches. The frost-free period is 130 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Eimarsh: Strong lead
- Pintailake: Strong lead
- Saltair: Strong lead
- Abbott: Strong lead
- Airport: Strong lead
- Bramwell: Strong lead
- Deckerman: Strong lead
- Jordan: Strong lead
See it on the map
Open a Lewiston spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Lewiston loam, 0 to 1 percent slopes, map unit Ir in Salt Lake Area, Utah.
- Official Series Description: Lewiston(revised 11/2005), established.
- Taxonomic class: Coarse-loamy, mixed, superactive, mesic Aquic Calcixerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.