Leonardtown soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 2 to 22 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Leonardtown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Leonardtown spot on the map
Rated from the USDA soil survey record for Leonardtown silt loam (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Btg" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 20 in (51 cm)).
- Note Typically starts within about 2 in (5 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilA A silt loam layer about 0 to 2 in down: about 24% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- Clay subsoilBtgbest layer A silty clay loam layer about 2 to 22 in down: about 28% clay, moderate plasticity when wet, gray when moist. Promising
- Clay subsoilBtgx A loam layer about 22 to 43 in down: about 18% clay, low plasticity when wet, gray when moist. Weak indication
- Loamy layerBCg A sandy clay loam layer about 43 to 80 in down: about 22% clay, moderate plasticity when wet, gray when moist. Possible
What it looks like raw
The clay subsoil (Btg), 2 to 22 in down in the typical profile: gray (10YR 5/1); slightly hard, friable; slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty eolian deposits over fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maryland, in these survey areas: Cecil County, Maryland; Harford County Area, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Distribution: Maryland Extent: Moderate
USDA, geographic setting: Landscape: Coastal Plain, upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Watchung: Strong lead
- Christiana: Strong lead
- Kelly: Strong lead
- Kinkora: Strong lead
- Lenni: Strong lead
- Baile: Promising
- Chillum: Promising
See it on the map
Open a Leonardtown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 75%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Leonardtown silt loam, map unit Lr in Harford County Area, Maryland.
- Official Series Description: Leonardtown(revised 07/2007), established.
- Taxonomic class: Fine-silty, mixed, active, mesic Typic Fragiaquults
- Rated with rule version 2026-09-28.1; the method is on the About page.