Legore soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 10 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Legore soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Legore silt loam, 15 to 25 percent slopes, moderately eroded (Harford County Area, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 31% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 14 in (36 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 24% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 10 in down: about 23% clay, moderate plasticity when wet, brown when moist. Possible
- Loamy layerH2best layer A gravelly silty clay loam layer about 10 to 24 in down: about 31% clay, high plasticity when wet, brown when moist. Possible
- Loamy layerH3 A gravelly silt loam layer about 24 to 66 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 66 to 70 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 10 to 24 in down in the typical profile: brown (7.5YR 4/4); very hard, very firm, sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: loamy residuum weathered from diabase and/or loamy residuum weathered from gabbro.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 66 in (168 cm) down.
Where it is mapped
Seen on the map as the most common soil in 30 map units in Maryland, Pennsylvania, in these survey areas: Baltimore County, Maryland; Cecil County, Maryland; Chester County, Pennsylvania; Harford County Area, Maryland.
By state: wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Maryland, Pennsylvania and Virginia. The series is of moderate extent.
USDA, geographic setting: They are nearly level to very steep slopes on dikes of intruded igneous rock with slopes ranging from 0 to 50 percent. The Legore soils formed in residuum from diabase, diorite and related rocks. The climate is temperate and humid with a mean annual temperature of 45 to 55 degrees F. and mean annual precipitation of 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Christiana: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
- Kelly: Strong lead
- Kinkora: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Legore silt loam, 15 to 25 percent slopes, moderately eroded, map unit LeD2 in Harford County Area, Maryland.
- Official Series Description: Legore(revised 02/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.