Leck Kill soil
Wild-clay potential
Weak indication
Weak indication: no layer of Leck Kill shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Leck Kill soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Leck Kill spot on the map
Rated from the USDA soil survey record for Leck kill channery silt loam, 0 to 3 percent slopes (Carbon County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 20% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (5.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 17 in (44 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 26% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 8 in down: about 18% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH2best layer A channery silt loam layer about 8 to 25 in down: about 20% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Sandy layerH3 A very channery silt loam layer about 25 to 32 in down: about 18% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- BedrockR Unweathered bedrock about 32 to 36 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 8 to 25 in down in the typical profile: reddish brown (2.5YR 4/4); firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Pennsylvania, in these survey areas: Carbon County, Pennsylvania; Lebanon County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Central and eastern Pennsylvania, Maryland, and West Virginia. The series is of large extent, estimated to be 100,000 acres.
USDA, geographic setting: Leck Kill soils are nearly level to very steep upland soils in convex positions. Slopes range from 0 to 60 percent. Leck Kill soils formed in a regolith of residuum or glacial till derived from red shale, siltstone, and sandstone. The climate is humid temperate. Average annual precipitation is 38 to 46 inches, average annual temperature is 48 degrees to 54 degrees F., and the frost-free season is about 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Comly: Promising
- Holly: Promising
- Shelmadine: Promising
- Bowmansville: Promising
- Brinkerton: Promising
- Bucks: Promising
See it on the map
Open a Leck Kill spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Leck kill channery silt loam, 0 to 3 percent slopes, map unit LeA in Carbon County, Pennsylvania.
- Official Series Description: Leck Kill(revised 07/2001), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.