Klej soil
Wild-clay potential
Weak indication
Weak indication: no layer of Klej shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Klej soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Klej loamy sand (Harford County, Aberdeen Proving Ground, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A loamy sand layer about 0 to 9 in down: about 6% clay, low plasticity when wet, very dark brown when moist. Weak indication
- Sandy layerH2best layer A loamy sand layer about 9 to 39 in down: about 6% clay, low plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerH3 A sand layer about 39 to 47 in down: about 6% clay, low plasticity when wet, pale yellow when moist. Weak indication
- Loamy layerH4 A sandy loam layer about 47 to 60 in down: about 19% clay, moderate plasticity when wet, pale yellow when moist. Weak indication
What it looks like raw
The sandy layer (H2), 9 to 39 in down in the typical profile: light yellowish brown (2.5Y 6/4); very friable; nonsticky; nonplastic. Raw colour is not fired colour.
About the soil
- USDA family particle-size class: not used.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Maryland, in these survey areas: Harford County, Aberdeen Proving Ground, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Maryland, Delaware, Massachusetts, New Jersey, and Virginia; Moderate
USDA, geographic setting: Landscape: Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Elkton: Promising
- Kentuck: Promising
- Lenape: Promising
- Beltsville: Possible
- Codorus: Possible
- Corsica: Possible
- Fallsington: Possible
- Hambrook: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Klej loamy sand, map unit Kj in Harford County, Aberdeen Proving Ground, Maryland.
- Official Series Description: Klej(revised 11/2015), established.
- Taxonomic class: Mesic, coated Aquic Quartzipsamments
- Rated with rule version 2026-09-28.1; the method is on the About page.