Kangas soil
Wild-clay potential
Weak indication
Weak indication: no layer of Kangas shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Kangas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Kangas coarse sandy loam, 0 to 2 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 9% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 0 in (0 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
- Lowers the potential Surface layer with about 3% organic matter; roots and organics complicate use.
Layer by layer
- TopsoilAbest layer A coarse sandy loam layer about 0 to 21 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC1 A fine gravelly loamy coarse sand layer about 21 to 40 in down: about 6% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerC2 A very gravelly coarse sand layer about 40 to 60 in down: about 5% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The topsoil (A), 0 to 21 in down in the typical profile: grayish brown (10YR 5/2), very dark grayish brown (10YR 3/2) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: outwash.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Distributed in the high colder mountain valleys, mainly in Valley County, Idaho. The soil is inextensive.
USDA, geographic setting: Kangas soils are on outwash plains and terraces. Slopes are 0 to 8 percent. They formed in glacial outwash. Elevations are 3,800 to 5,100 feet. Average annual precipitation is 22 to 24 inches. Average January temperature is 20 degrees F.; average July temperature is 64 degrees F. Average annual temperature is 38 degrees to 40 degrees F. Frost-free season is about 60 to 80 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Culdecole: Promising
- Nisula: Promising
- Archabal: Possible
- Tica: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Kangas coarse sandy loam, 0 to 2 percent slopes, map unit 106 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Kangas(revised 03/2008), established.
- Taxonomic class: Sandy, mixed Typic Humicryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.