Jurvannah soil
Wild-clay potential
Weak indication
Weak indication: no layer of Jurvannah shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Jurvannah soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Jurvannah spot on the map
Rated from the USDA soil survey record for Jurvannah sandy loam (Valley Area, Idaho, Parts of Adams and Valley Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 5% clay.
- Lowers the potential Low engineering plasticity index (2): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 38 in (96 cm)).
- Note Typically starts within about 22 in (56 cm) of the surface.
- Lowers the potential High rock content (about 36% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A sandy loam layer about 0 to 6 in down: about 9% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerC1 A fine gravelly sand layer about 6 to 22 in down: about 5% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerC2best layer A very gravelly sand layer about 22 to 60 in down: about 5% clay, low plasticity when wet, white when moist. Weak indication
What it looks like raw
The sandy layer (C2), 22 to 60 in down in the typical profile: white (10YR 8/1), and brownish yellow (10YR 6/6), brownish yellow (10YR 6/6) moist; loose. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from granite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Idaho, in these survey areas: Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Valley County, Idaho. The series is inextensive.
USDA, geographic setting: Jurvannah soils are on alluvial fans, low stream terraces, or flood plains and have slopes of 0 to 2 percent. They formed in coarse textured alluvium from granitic rocks. Elevations are 4,800 to 5,100 feet. Mean annual precipitation is 22 to 24 inches. mean annual temperature is 38 degrees to 40 degrees F., and mean summer temperature is 53 degrees to 55 degrees F. Frost-free season is 50 to 70 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Blackwell: Promising
- Nisula: Promising
- Swede: Promising
- Archabal: Possible
- Tica: Possible
- Bluebell: Weak indication
- Bryan: Weak indication
See it on the map
Open a Jurvannah spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Jurvannah sandy loam, map unit 27 in Valley Area, Idaho, Parts of Adams and Valley Counties.
- Official Series Description: Jurvannah, established.
- Taxonomic class: Sandy-skeletal, mixed Typic Cryaquents
- Rated with rule version 2026-09-28.1; the method is on the About page.