Houghtonville soil
Wild-clay potential
Weak indication
Weak indication: no layer of Houghtonville shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Houghtonville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Houghtonville spot on the map
Rated from the USDA soil survey record for Houghtonville fine sandy loam, 8 to 15 percent slopes, very stony (Washington County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 7% clay.
- Lowers the potential Low engineering plasticity index (5): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 33 in (83 cm)).
- Note Typically starts about 33 in (85 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Organic top layerO1 An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- Sandy layerH1 A fine sandy loam layer about 1 to 5 in down: about 7% clay, low plasticity when wet, black when moist. Weak indication
- Sandy layerH2 A gravelly fine sandy loam layer about 5 to 33 in down: about 7% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH3best layer A gravelly fine sandy loam layer about 33 to 66 in down: about 7% clay, low plasticity when wet, light olive brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 33 to 66 in down in the typical profile: light olive brown (2.5Y 5/4); friable. Raw colour is not fired colour.
About the soil
- Parent material: coarse-loamy till.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Vermont, in these survey areas: Washington County, Vermont.
By state: wild clay in Vermont.
USDA, distribution and extent: Vermont and New York; MLRAs 143 and 144B. The series is of moderate extent.
USDA, geographic setting: Houghtonville soils are on gently sloping to very steep glaciated uplands. They are on mountain side slopes, mountain tops, mountain ridges, hill tops, and hill slopes. Slope ranges from 3 to 70 percent. The soils formed in loamy till of Wisconsin age that is derived mainly from schist, gneiss, granite, or anorthosite. Mean annual precipitation ranges from about 40 to 60 inches, and the mean annual temperature ranges from 38 to 44 degrees F. The frost-free season ranges from about 60 to 120 days. Elevation is typically between about 1,500 and 2,500 feet.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Adams: Weak indication
- Berkshire: Weak indication
- Cabot: Weak indication
- Colonel: Weak indication
- Colton: Weak indication
- Grange: Weak indication
See it on the map
Open a Houghtonville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Houghtonville fine sandy loam, 8 to 15 percent slopes, very stony, map unit 163C in Washington County, Vermont.
- Official Series Description: Houghtonville(revised 11/2015), established.
- Taxonomic class: Coarse-loamy, isotic, frigid Typic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.