Colonel soil
Wild-clay potential
Weak indication
Weak indication: no layer of Colonel shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Colonel soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Colonel spot on the map
Rated from the USDA soil survey record for Colonel fine sandy loam, 3 to 8 percent slopes (Washington County, Vermont) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 47 in (120 cm)).
- Note Typically starts within about 18 in (45 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 15% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilAp A fine sandy loam layer about 0 to 7 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBs1 A fine sandy loam layer about 7 to 9 in down: about 3% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerBs2 A fine sandy loam layer about 9 to 12 in down: about 3% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
- Sandy layerBC A gravelly fine sandy loam layer about 12 to 18 in down: about 3% clay, low plasticity when wet, light olive brown when moist. Weak indication
- Sandy layerCdbest layer A gravelly fine sandy loam layer about 18 to 65 in down: about 3% clay, low plasticity when wet, olive when moist. Weak indication
What it looks like raw
The sandy layer (Cd), 18 to 65 in down in the typical profile: olive (5Y 4/3); gravelly fine sandy loam; very firm. Raw colour is not fired colour.
About the soil
- Parent material: loamy lodgment till derived from mica schist and/or loamy lodgment till derived from granite and/or loamy lodgment till derived from phyllite.
- USDA family particle-size class: loamy.
- Drainage: somewhat poorly drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Maine, Vermont, in these survey areas: Franklin County Area and Part of Somerset County, Maine; Somerset County Area and Parts of Franklin and Oxford Counties, Maine; Washington County, Vermont.
By state: wild clay in Maine,wild clay in Vermont.
USDA, distribution and extent: Maine and Vermont. MLRAs 143 and 144B. The series is of large extent.
USDA, geographic setting: Colonel soils are on nearly level to moderately steep slopes in glaciated uplands. They are typically on slightly convex to concave parts of backslopes, footslopes, and toeslopes, but they also occur on till plains. The soils formed in loamy lodgment till derived mainly from schist, gneiss, phyllite, and granite. Slope ranges from 0 to 35 percent. The mean annual precipitation is 790 to 1640 mm, and the mean annual temperature is 2 to 7 degrees C. The frost-free period ranges from 90 to 160 days. Elevation ranges from about 2 to 800 meters above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Buxton: Strong lead
- Lamoine: Strong lead
- Swanville: Possible
- Colton: Weak indication
- Peru: Weak indication
- Adams: Weak indication
- Hogback: Weak indication
- Marlow: Weak indication
See it on the map
Open a Colonel spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 86%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Colonel fine sandy loam, 3 to 8 percent slopes, map unit 14B in Washington County, Vermont.
- Official Series Description: Colonel(revised 06/2016), established.
- Taxonomic class: Loamy, isotic, frigid, shallow Aquic Haplorthods
- Rated with rule version 2026-09-28.1; the method is on the About page.