Honga soil
Wild-clay potential
Promising
Promising: a loamy layer with some clay typically about 36 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Honga soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Honga peat, 0 to 1 percent slopes, very frequently flooded, tidal (Fairfax County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 34% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (20): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts about 36 in (91 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 7 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 7 to 13 in down, not a clay body. Weak indication
- Organic top layerOa An organic top layer about 13 to 22 in down, not a clay body. Weak indication
- Loamy layerH1 A silt loam layer about 22 to 36 in down: about 25% clay, moderate plasticity when wet, gray when moist. Possible
- Loamy layerH2best layer A silty clay loam layer about 36 to 60 in down: about 34% clay, high plasticity when wet, dark gray when moist. Promising
What it looks like raw
The loamy layer (H2), 36 to 60 in down in the typical profile: dark gray (5Y 4/1); very firm; slightly sticky, slightly plastic; nonfluid. Raw colour is not fired colour.
About the soil
- Parent material: organic material over loamy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy.
- Drainage: very poorly drained.
- Rated hydric (wetland) soil; often saturated and protected.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Fairfax County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: General Area--Coastal plain of Maryland and Virginia
USDA, geographic setting: Parent material--Herbaceous organic deposits over loamy fluviomarine deposits
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Gunston: Strong lead
- Lunt: Strong lead
- Orange: Strong lead
- Sumerduck: Strong lead
- Elkton: Promising
- Elsinboro: Promising
- Fairfax: Promising
- Glenelg: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 95%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Honga peat, 0 to 1 percent slopes, very frequently flooded, tidal, map unit 60A in Fairfax County, Virginia.
- Official Series Description: Honga(revised 02/2025), established.
- Taxonomic class: Loamy, mixed, euic, mesic Terric Sulfihemists
- Rated with rule version 2026-09-28.1; the method is on the About page.