Sumerduck soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 4 to 31 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Sumerduck soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Sumerduck spot on the map
Rated from the USDA soil survey record for Sumerduck loam, 2 to 7 percent slopes, frequently flooded (Fauquier County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 35% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (25): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 27 in (69 cm)).
- Note Typically starts within about 4 in (10 cm) of the surface.
- Note Few rock fragments (about 8% by volume).
Layer by layer
- TopsoilH1 A loam layer about 0 to 4 in down: about 23% clay, moderate plasticity when wet, brown when moist. Weak indication
- Clay-rich layerH2best layer A silty clay loam layer about 4 to 31 in down: about 35% clay, high plasticity when wet, strong brown when moist. Strong lead
- Loamy layerH3 A silt loam layer about 31 to 100 in down: about 18% clay, moderate plasticity when wet, yellowish red when moist. Possible
What it looks like raw
The clay-rich layer (H2), 4 to 31 in down in the typical profile: strong brown (7.5YR 5/8); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium derived from schist and/or alluvium derived from phyllite.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Virginia, in these survey areas: Alexandria City, Virginia; Fairfax County, Virginia; Fauquier County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: MLRA 136 (mesic) and 148. The soils are of small extent.
USDA, geographic setting: Sumerduck soils formed in alluvium and slope alluvium from schist, phyllite, metamonzonite and gneiss in the Northern Piedmont. Sumerduck soils are in drainageways that are subject to frequent, extremely brief, flash flooding events with little or no deposition or erosion. Slope gradients range from 0 to 8 percent. Mean annual air temperature ranges from 53 to 57 degrees F, mean annual precipitation ranges from 387 to 44 inches, frost free days range from 165 to 203 days, and elevation ranges from 100 feet to 400 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lunt: Strong lead
- Albano: Strong lead
- Appling: Strong lead
- Cecil: Strong lead
- Clover: Strong lead
- Dulles: Strong lead
- Fletcherville: Strong lead
- Gunston: Strong lead
See it on the map
Open a Sumerduck spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Sumerduck loam, 2 to 7 percent slopes, frequently flooded, map unit 13B in Fauquier County, Virginia.
- Official Series Description: Sumerduck(revised 03/2022), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Aquic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.