Orange soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 6 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Orange soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Orange-Iredell loams, 2 to 7 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 48% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (39): USDA's estimate suggests plastic behavior when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 37 in (94 cm)).
- Note Typically starts within about 6 in (15 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
- Note High shrink-swell (linear extensibility about 7.5%): often very plastic, and prone to cracking as it dries.
- Note Engineering class CH: a clay of high plasticity in the Unified system.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 6 in down: about 19% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 6 to 43 in down: about 48% clay, high plasticity when wet, olive when moist. Strong lead
- Loamy layerH3 A sandy clay loam layer about 43 to 65 in down: about 23% clay, moderate plasticity when wet, olive when moist. Possible
What it looks like raw
The clay-rich layer (H2), 6 to 43 in down in the typical profile: olive (5Y 5/4); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed mafic residuum.
- USDA family mineralogy: smectitic. Smectite-rich clays are usually very plastic and shrink a lot as they dry.
- USDA family particle-size class: fine.
- Drainage: somewhat poorly drained.
- Paralithic bedrock typically about 50 in (127 cm) down.
Where it is mapped
Seen on the map as the most common soil in 6 map units in Virginia, in these survey areas: Fairfax County, Virginia; Spotsylvania County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Distribution: Virginia and North Carolina.
USDA, geographic setting: Landscape: Piedmont
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Turbeville: Strong lead
- Bladen: Strong lead
- Brockroad: Strong lead
- Caroline: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Orange-Iredell loams, 2 to 7 percent slopes, map unit 33B in Spotsylvania County, Virginia.
- Official Series Description: Orange(revised 12/2015), established.
- Taxonomic class: Fine, smectitic, mesic Albaquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.