Brockroad soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 9 to 43 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Brockroad soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Brockroad spot on the map
Rated from the USDA soil survey record for Brockroad silt loam, 2 to 7 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 34 in (86 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A silt loam layer about 0 to 9 in down: about 19% clay, low plasticity when wet, pale brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 9 to 43 in down: about 50% clay, high plasticity when wet, yellowish brown when moist. Strong lead
- Clay-rich layerH3 A silty clay loam layer about 43 to 75 in down: about 38% clay, moderate plasticity when wet, yellowish red when moist. Promising
- BedrockH4 Bedrock about 75 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 9 to 43 in down in the typical profile: yellowish brown (10YR 5/8); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from mica schist.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 75 in (191 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Virginia, in these survey areas: Spotsylvania County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Virginia; possibly North Carolina and South Carolina. The series is of moderate extent.
USDA, geographic setting: The Brockroad soils are on slightly convex upland ridges and sideslopes. Slope gradients are commonly 2 to 7 percent with a range of 0 to 15 percent. These soils formed in a mantle of silty and clayey sediments containing reddish quartz pebbles, and underlying clayey materials weathered from mica schist and gneiss. Mean annual air temperature is above 15 degrees C and the mean annual precipitation is about 107 cm.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Catharpin: Strong lead
- Cecil: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Fluvanna: Strong lead
- Masada: Strong lead
- Orange: Strong lead
See it on the map
Open a Brockroad spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Brockroad silt loam, 2 to 7 percent slopes, map unit 9B in Spotsylvania County, Virginia.
- Official Series Description: Brockroad(revised 09/2021), established.
- Taxonomic class: Fine, mixed, semiactive, thermic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.