Fluvanna soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 10 to 49 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fluvanna soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fluvanna spot on the map
Rated from the USDA soil survey record for Fluvanna fine sandy loam, 2 to 7 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 50% clay in the fine-earth portion.
- Raises the potential High engineering plasticity index (22): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 39 in (99 cm)).
- Note Typically starts within about 10 in (25 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 10 in down: about 16% clay, low plasticity when wet, strong brown when moist. Weak indication
- Clay-rich layerH2best layer A clay layer about 10 to 49 in down: about 50% clay, high plasticity when wet, yellowish red when moist. Strong lead
- Loamy layerH3 A clay loam layer about 49 to 73 in down: about 30% clay, moderate plasticity when wet, brownish yellow when moist. Possible
- BedrockH4 Bedrock about 73 to 79 in down: no clay layer to dig. Weak indication
What it looks like raw
The clay-rich layer (H2), 10 to 49 in down in the typical profile: yellowish red (5YR 5/8); firm, moderately sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: mixed mafic residuum.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
- Paralithic bedrock typically about 73 in (185 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Virginia, in these survey areas: Spotsylvania County, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Distribution: Virginia and possibly North Carolina.
USDA, geographic setting: Landscape: Piedmont
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Brockroad: Strong lead
- Catharpin: Strong lead
- Cecil: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Masada: Strong lead
- Orange: Strong lead
See it on the map
Open a Fluvanna spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fluvanna fine sandy loam, 2 to 7 percent slopes, map unit 22B in Spotsylvania County, Virginia.
- Official Series Description: Fluvanna(revised 10/2007), established.
- Taxonomic class: Fine, mixed, active, thermic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.