Turbeville soil
Wild-clay potential
Strong lead
Strong lead: a clayey layer typically about 12 to 65 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Turbeville soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Turbeville spot on the map
Rated from the USDA soil survey record for Turbeville loam, 2 to 7 percent slopes (Spotsylvania County, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 40% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (17).
- Raises the potential The official series description calls the wet soil very sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 53 in (135 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 2% by volume).
Layer by layer
- Loamy layerH1 A loam layer about 0 to 12 in down: about 20% clay, moderate plasticity when wet, brown when moist. Possible
- Clay-rich layerH2best layer A clay layer about 12 to 65 in down: about 40% clay, moderate plasticity when wet, red when moist. Strong lead
What it looks like raw
The clay-rich layer (H2), 12 to 65 in down in the typical profile: red (2.5YR 4/8); friable; very sticky, moderately plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family mineralogy: kaolinitic. Kaolinite-dominated clays are typically less plastic than smectitic clays.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 4 map units in Virginia, in these survey areas: Spotsylvania County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Piedmont Plateau and portions of the upper Coastal Plain of Virginia and North Carolina. The series is of moderate extent.
USDA, geographic setting: These soils are on nearly level to steep slopes on high terraces bordering major streams in the Piedmont and upper Atlantic Coastal Plain. Slope gradients are commonly from 0 to 10 percent with a range of 0 to 35 percent. These soils developed in old alluvium derived mainly from land surfaces underlain by acid igneous and metamorphic rocks of the Piedmont Plateau. The mean annual temperature ranges from 57 to 64 degrees F, and mean annual precipitation is about 36 to 50 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Appling: Strong lead
- Cecil: Strong lead
- Cullen: Strong lead
- Dogue: Strong lead
- Orange: Strong lead
- Bladen: Strong lead
- Brockroad: Strong lead
- Caroline: Strong lead
See it on the map
Open a Turbeville spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Turbeville loam, 2 to 7 percent slopes, map unit 43B in Spotsylvania County, Virginia.
- Official Series Description: Turbeville(revised 04/2003), established.
- Taxonomic class: Fine, kaolinitic, thermic Typic Kandiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.