Fairfax soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 46 to 76 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Fairfax soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Fairfax spot on the map
Rated from the USDA soil survey record for Fairfax loam, 2 to 6 percent slopes (Stafford and King George Counties, Virginia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 38% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (16).
- Note Thick enough to investigate (about 30 in (76 cm)).
- Note Typically starts about 46 in (117 cm) down; expect real digging or look for cuts and banks.
- Missing data Rock fragment content is not reported.
- Missing data Held at "Promising" because no plasticity evidence is available; a high clay percentage alone does not make a strong lead.
Layer by layer
- Sandy layerH1 A loam layer about 0 to 11 in down: about 15% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerH2 A silty clay loam layer about 11 to 24 in down: about 32% clay, moderate plasticity when wet, strong brown when moist. Promising
- Clay-rich layerH3 A gravelly silty clay loam layer about 24 to 46 in down: about 38% clay, moderate plasticity when wet, yellowish red when moist. Promising
- Clay-rich layerH4best layer A silty clay loam layer about 46 to 76 in down: about 38% clay, moderate plasticity when wet, strong brown when moist. Promising
- Loamy layerH5 A silt loam layer about 76 to 80 in down: about 23% clay, moderate plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The clay-rich layer (H4), 46 to 76 in down in the typical profile: strong brown (7.5YR 5/6), yellowish red (5YR 5/6), and weak red (10YR 5/3); friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from granite and gneiss.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Virginia, in these survey areas: Alexandria City, Virginia; Fairfax County, Virginia; Prince William County, Virginia; Stafford and King George Counties, Virginia.
By state: wild clay in Virginia.
USDA, distribution and extent: Northern Virginia and possibly Maryland. The series is of moderate extent.
USDA, geographic setting: Fairfax soils are on nearly level to
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lunt: Strong lead
- Appling: Strong lead
- Caroline: Strong lead
- Cecil: Strong lead
- Orange: Strong lead
- Sumerduck: Strong lead
- Susquehanna: Strong lead
- Worsham: Strong lead
See it on the map
Open a Fairfax spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Fairfax loam, 2 to 6 percent slopes, map unit FaB in Stafford and King George Counties, Virginia.
- Official Series Description: Fairfax(revised 02/2022), established.
- Taxonomic class: Fine, mixed, subactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.