Hoghole soil
Wild-clay potential
Weak indication
Weak indication: no layer of Hoghole shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Hoghole soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Hoghole spot on the map
Rated from the USDA soil survey record for Hoghole-Grosstown complex, 0 to 5 percent slopes (Charles County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 47 in (119 cm)).
- Note Typically starts about 33 in (84 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 60% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilA A sand layer about 0 to 4 in down: about 3% clay, low plasticity when wet, very dark grayish brown when moist. Weak indication
- Sandy layerBw1 A very gravelly sand layer about 4 to 33 in down: about 3% clay, low plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBw2best layer An extremely gravelly coarse sand layer about 33 to 80 in down: about 3% clay, low plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The sandy layer (Bw2), 33 to 80 in down in the typical profile: strong brown (7.5YR 5/8); extremely gravelly loamy sand; loose; nonsticky, nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: sandy and gravelly fluviomarine deposits.
- USDA family mineralogy: siliceous.
- USDA family particle-size class: sandy-skeletal.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Maryland, in these survey areas: Charles County, Maryland; Prince George's County, Maryland.
By state: wild clay in Maryland.
USDA, geographic setting: Landscape: Coastal Plain, upland
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Lenni: Strong lead
- Magnolia: Strong lead
- Christiana: Strong lead
- Howell: Strong lead
- Elkton: Promising
- Liverpool: Promising
- Nanticoke: Promising
- Piccowaxen: Promising
See it on the map
Open a Hoghole spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 45%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Hoghole-Grosstown complex, 0 to 5 percent slopes, map unit HgB in Charles County, Maryland.
- Official Series Description: Hoghole(revised 11/2015), established.
- Taxonomic class: Sandy-skeletal, siliceous, mesic Typic Udorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.