Havre soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 5 to 60 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Havre soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Havre loam (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (10).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 55 in (139 cm)).
- Note Typically starts within about 5 in (13 cm) of the surface.
- Missing data Rock fragment content is not reported.
- Note USDA reports about 6% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 5 in down: about 20% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2best layer A stratified fine sand to silty clay layer about 5 to 60 in down: about 24% clay, moderate plasticity when wet, light brownish gray when moist. Possible
What it looks like raw
The loamy layer (H2), 5 to 60 in down in the typical profile: light brownish gray (2.5Y 6/2), dark grayish brown (2.5Y 4/2) moist; slightly hard, very friable, slightly sticky and slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: alluvium.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Havre soils are extensive in the plains area of Montana and in the states of Colorado, North Dakota, Nebraska, South Dakota, Utah, and Wyoming.
USDA, geographic setting: Landform - flood plains; alluvial fans; stream terraces. Elevation - 1,900 to 6,000 feet in Montana; ranges to 7,300 feet in Utah. Slope- 0 to 6 percent. Parent material - stratified calcareous loamy alluvium. Climate - long, cold winters; moist springs; warm summers. Mean annual precipitation - 10 to 16 inches, most of which falls during spring and the early part of summer. Mean annual air temperature - 38 to 45 degrees F. Frost-free period - 90 to 135 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Havre loam, map unit Hb in Meade County, South Dakota, Northern Part.
- Official Series Description: Havre(revised 06/2000), established.
- Taxonomic class: Fine-loamy, mixed, superactive, calcareous, frigid Aridic Ustifluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.