Ellicott soil
Wild-clay potential
Weak indication
Weak indication: no layer of Ellicott shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Ellicott soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Ellicott spot on the map
Rated from the USDA soil survey record for Ellicott-Ellicott sandy-skeletal complex, 0 to 3 percent slopes, rarely flooded (Weld County, Colorado, Southern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 36 in (91 cm)).
- Note Typically starts about 44 in (112 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilA A sand layer about 0 to 4 in down: about 2% clay, low plasticity when wet, grayish brown when moist. Weak indication
- TopsoilAC A sand layer about 4 to 13 in down: about 2% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC1 A sand layer about 13 to 30 in down: about 1% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC2 A sand layer about 30 to 44 in down: about 1% clay, low plasticity when wet, light brownish gray when moist. Weak indication
- Sandy layerC3best layer A coarse sand layer about 44 to 80 in down: about 2% clay, low plasticity when wet, light brownish gray when moist. Weak indication
What it looks like raw
The sandy layer (C3), 44 to 80 in down in the typical profile: light brownish gray (10YR 6/2), dark grayish brown (10YR 4/2) moist; slightly hard, loose. Raw colour is not fired colour.
About the soil
- Parent material: noncalcareous, stratified sandy alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in Colorado, in these survey areas: Weld County, Colorado, Southern Part.
By state: wild clay in Colorado.
USDA, distribution and extent: Eastern and central Colorado. The soils are of moderate extent.
USDA, geographic setting: Ellicott soils are on terraces and floodplains and have slopes of 0 to 6 percent. They formed in noncalcareous, stratified sandy alluvium derived from arkose beds or granite. Elevations are from 5,200 to 7,400 feet. Mean annual precipitation is about 11 to 17 inches. Mean annual temperature is about 46 to 51 degrees F. Frost-free season is about 115 to 150 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Heldt: Strong lead
- Midway: Strong lead
- Nunn: Strong lead
- Renohill: Strong lead
- Ulm: Strong lead
- Weld: Strong lead
- Colby: Promising
- Colombo: Promising
See it on the map
Open a Ellicott spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Ellicott-Ellicott sandy-skeletal complex, 0 to 3 percent slopes, rarely flooded, map unit 10 in Weld County, Colorado, Southern Part.
- Official Series Description: Ellicott(revised 11/2007), established.
- Taxonomic class: Sandy, mixed, mesic Ustic Torrifluvents
- Rated with rule version 2026-09-28.1; the method is on the About page.