Duston soil
Wild-clay potential
Weak indication
Weak indication: no layer of Duston shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Duston soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Duston sandy loam, 0 to 2 percent slopes (Valley Area, Idaho, Parts of Adams and Valley Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (1): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 51 in (130 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Note Few rock fragments (about 11% by volume).
Layer by layer
- Organic top layerOi An organic top layer about 0 to 2 in down, not a clay body. Weak indication
- Organic top layerOe An organic top layer about 2 to 3 in down, not a clay body. Weak indication
- TopsoilAB A sandy loam layer about 3 to 8 in down: about 10% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerC1 A sandy loam layer about 8 to 12 in down: about 10% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerC2best layer A coarse sand layer about 12 to 63 in down: about 3% clay, low plasticity when wet, yellowish brown when moist. Weak indication
What it looks like raw
The sandy layer (C2), 12 to 63 in down in the typical profile: yellowish brown (10YR 5/4); coarse sand; loose. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Idaho, in these survey areas: Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: Occurs on recent outwash plains near the Payette lakes and along streams in Valley County, Idaho. The soils are not extensive.
USDA, geographic setting: Duston soils are on glacial outwash plains.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Blackwell: Promising
- Nisula: Promising
- Swede: Promising
- Archabal: Possible
- Tica: Possible
- Bluebell: Weak indication
- Bryan: Weak indication
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Duston sandy loam, 0 to 2 percent slopes, map unit 20 in Valley Area, Idaho, Parts of Adams and Valley Counties.
- Official Series Description: Duston(revised 03/2004), established.
- Taxonomic class: Sandy, mixed Typic Dystrocryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.