Donnel soil
Wild-clay potential
Weak indication
Weak indication: no layer of Donnel shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Donnel soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Donnel sandy loam, 0 to 4 percent slopes (Adams-Washington Area, Parts of Adams and Washington Counties, Idaho) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 6% clay.
- Lowers the potential Low engineering plasticity index (3): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts about 39 in (99 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 7% by volume).
Layer by layer
- TopsoilA A sandy loam layer about 0 to 20 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerBC A sandy loam layer about 20 to 39 in down: about 8% clay, low plasticity when wet, very pale brown when moist. Weak indication
- Sandy layerCbest layer A loamy sand layer about 39 to 60 in down: about 6% clay, low plasticity when wet, very pale brown when moist. Weak indication
What it looks like raw
The sandy layer (C), 39 to 60 in down in the typical profile: very pale brown (10YR 7/4), yellowish brown (10YR 5/4) moist; soft, very friable. Raw colour is not fired colour.
About the soil
- Parent material: mixed alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: coarse-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Idaho, in these survey areas: Adams-Washington Area, Parts of Adams and Washington Counties, Idaho; South Idaho Forests, Idaho; Valley Area, Idaho, Parts of Adams and Valley Counties.
By state: wild clay in Idaho.
USDA, distribution and extent: The high mountain valley areas of central Idaho. The series is inextensive.
USDA, geographic setting: Donnel soils are on alluvial fans and terraces and have slopes of 0 to 12 percent. They formed in alluvial material that has weathered from granite. Elevations are3,800to 5,100 feet. Average annual precipitation is 22 to 24 inches. Average annual temperature is 38 degrees to 43 degrees F. Frost-free season is about 65 to 75 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Cabarton: Strong lead
- Sudpeak: Strong lead
- Blackwell: Promising
- Swede: Promising
- Catherine: Promising
- Culdecole: Promising
- Nisula: Promising
- Ticanot: Possible
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Donnel sandy loam, 0 to 4 percent slopes, map unit 63 in Adams-Washington Area, Parts of Adams and Washington Counties, Idaho.
- Official Series Description: Donnel(revised 03/2008), established.
- Taxonomic class: Coarse-loamy, mixed, superactive Typic Humicryepts
- Rated with rule version 2026-09-28.1; the method is on the About page.