Deskamp soil
Wild-clay potential
Weak indication
Weak indication: no layer of Deskamp shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Deskamp soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Deskamp spot on the map
Rated from the USDA soil survey record for Deskamp loamy sand, 0 to 3 percent slopes (Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 15 in (38 cm)).
- Note Typically starts within about 17 in (43 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 30% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A loamy sand layer about 0 to 10 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A loamy sand layer about 10 to 17 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A gravelly loamy sand layer about 17 to 32 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
- BedrockH4 Unweathered bedrock about 32 to 42 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (H3), 17 to 32 in down in the typical profile: pale brown (10YR 6/3), brown (10YR 4/3) moist; slightly hard, very friable, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over basalt.
- USDA family particle-size class: ashy.
- Drainage: somewhat excessively drained.
- Lithic bedrock typically about 32 in (81 cm) down.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Oregon, in these survey areas: Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Deschutes Basin of Central Oregon; MLRA 10. The series is of small extent.
USDA, geographic setting: Deskamp soils are on lava plains at elevations of 3000 to 4,000 feet. Slopes are 0 to 15 percent. The soils formed in ash. The climate is characterized by cool, moist winters and hot, dry summers. The mean annual precipitation is 8 to 12 inches. The mean annual temperature is 47 to 52 degrees F. The frost-free period is 70 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Ninemile: Promising
- Reluctan: Promising
- Goodtack: Possible
- Hackleman: Possible
- Vergas: Possible
- Bluesters: Weak indication
See it on the map
Open a Deskamp spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Deskamp loamy sand, 0 to 3 percent slopes, map unit 36A in Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
- Official Series Description: Deskamp(revised 01/2009), established.
- Taxonomic class: Ashy, glassy, mesic Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.