Delridge soil
Wild-clay potential
Possible
Possible: a loamy layer with some clay typically about 3 to 24 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Delridge soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Delridge spot on the map
Rated from the USDA soil survey record for Delridge-Cabbart loams, 6 to 15 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 24% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note Thick enough to investigate (about 21 in (53 cm)).
- Note Typically starts within about 3 in (8 cm) of the surface.
- Note Few rock fragments (about 4% by volume).
- Note USDA reports about 15% calcium carbonate; lime in a clay body deserves testing.
Layer by layer
- Loamy layerH1 A loam layer about 0 to 3 in down: about 23% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2best layer A loam layer about 3 to 24 in down: about 24% clay, moderate plasticity when wet, light brownish gray when moist. Possible
- BedrockCr Weathered bedrock about 24 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 3 to 24 in down in the typical profile: light brownish gray (2.5Y 6/2); hard, friable. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from siltstone.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (77 cm) down.
Where it is mapped
Seen on the map as the most common soil in 1 map unit in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Northwestern South Dakota and possibily eastern Montana. It is of moderate extent.
USDA, geographic setting: Delridge soils are on uplands at elevations of 2,500 to 3,500 feet. They formed in residuum weathered from soft sedimentary rocks. Surfaces are convex and slopes range from 2 to 40 percent. The mean annual temperature ranges from 39 to 45 degrees F, and the mean annual precipitation ranges from 13 to 15
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Open a Delridge spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 55%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Delridge-Cabbart loams, 6 to 15 percent slopes, map unit DeC in Meade County, South Dakota, Northern Part.
- Official Series Description: Delridge, established.
- Taxonomic class: Fine-loamy, mixed, superactive, calcareous, frigid Aridic Ustorthents
- Rated with rule version 2026-09-28.1; the method is on the About page.