Croom soil
Wild-clay potential
Weak indication
Weak indication: no layer of Croom shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Croom soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Croom very gravelly sandy loam, 0 to 8 percent slopes (District of Columbia) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 28% clay in the fine-earth portion.
- Note USDA labels this a "Bt3" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (12).
- Lowers the potential The official series description calls the wet soil moderately sticky and nonplastic.
- Note Thick enough to investigate (about 24 in (61 cm)).
- Note Typically starts about 30 in (76 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential High rock content (about 77% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp1 A very gravelly sandy loam layer about 0 to 1 in down: about 17% clay, moderate plasticity when wet, very dark brown when moist. Weak indication
- TopsoilAp2 A loam layer about 1 to 9 in down: about 21% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Clay subsoilBt1 A very gravelly clay loam layer about 9 to 13 in down: about 36% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBt2 An extremely gravelly sandy clay loam layer about 13 to 30 in down: about 34% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Clay subsoilBt3best layer An extremely gravelly sandy clay loam layer about 30 to 54 in down: about 28% clay, moderate plasticity when wet, dark yellowish brown when moist. Weak indication
- Loamy layerBCt An extremely gravelly sandy clay loam layer about 54 to 66 in down: about 25% clay, moderate plasticity when wet, strong brown when moist. Weak indication
- Sandy layerBC An extremely gravelly coarse sandy loam layer about 66 to 80 in down: about 14% clay, low plasticity when wet, dark yellowish brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt3), 30 to 54 in down in the typical profile: dark yellowish brown (10YR 4/6); extremely gravelly sandy clay loam; friable, moderately sticky, nonplastic. Raw colour is not fired colour.
About the soil
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 30 map units in District of Columbia, Maryland, in these survey areas: Baltimore County, Maryland; Charles County, Maryland; District of Columbia; Prince George's County, Maryland.
By state: wild clay in District of Columbia,wild clay in Maryland.
USDA, geographic setting: Landscape: Northern Atlantic Coastal Plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Christiana: Strong lead
- Lenni: Strong lead
- Magnolia: Strong lead
- Benevola: Strong lead
- Cumberstone: Strong lead
- Dunning: Strong lead
- Howell: Strong lead
- Jackland: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Croom very gravelly sandy loam, 0 to 8 percent slopes, map unit CwB in District of Columbia.
- Official Series Description: Croom(revised 11/2015), established.
- Taxonomic class: Loamy-skeletal, siliceous, semiactive, mesic Typic Hapludults
- Rated with rule version 2026-09-28.1; the method is on the About page.