Clovkamp soil
Wild-clay potential
Weak indication
Weak indication: no layer of Clovkamp shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Clovkamp soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Clovkamp spot on the map
Rated from the USDA soil survey record for Clovkamp loamy sand, 0 to 3 percent slopes (Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 2% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Lowers the potential The official series description calls the wet soil nonsticky and nonplastic.
- Note Thick enough to investigate (about 16 in (41 cm)).
- Note Typically starts about 24 in (61 cm) down; expect real digging or look for cuts and banks.
- Lowers the potential Noticeable rock fragments (about 20% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- Sandy layerH1 A loamy sand layer about 0 to 12 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH2 A loamy sand layer about 12 to 24 in down: about 2% clay, low plasticity when wet, brown when moist. Weak indication
- Sandy layerH3best layer A gravelly loamy fine sand layer about 24 to 40 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH4 An extremely gravelly sand layer about 40 to 50 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
- Sandy layerH5 An extremely gravelly sand layer about 50 to 60 in down: about 2% clay, low plasticity when wet, pale brown when moist. Weak indication
What it looks like raw
The sandy layer (H3), 24 to 40 in down in the typical profile: pale brown (10YR 6/3), dark grayish brown (10YR 4/2) moist; hard, firm and brittle, nonsticky and nonplastic. Raw colour is not fired colour.
About the soil
- Parent material: volcanic ash over gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: ashy over sandy or sandy-skeletal.
- Drainage: somewhat excessively drained.
Where it is mapped
Seen on the map as the most common soil in 2 map units in Oregon, in these survey areas: Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
By state: wild clay in Oregon.
USDA, distribution and extent: Deschutes Basin of Central Oregon; MLRA 10. The series is not extensive.
USDA, geographic setting: Clovkamp soils are on old stream terraces on lava plains. These soils formed in volcanic ash overlying gravelly alluvium. The climate is characterized by cool, moist winters and hot, dry summers. Slopes are 0 to 25 percent. Elevations range from 3000 to 4000 feet. The mean annual precipitation is 8 to 12 inches. The mean annual temperature is 47 to 52 degrees F. The frost free period is 70 to 100 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Moonbeam: Strong lead
- Swalesilver: Strong lead
- Ninemile: Promising
- Reluctan: Promising
- Goodtack: Possible
- Hackleman: Possible
- Vergas: Possible
- Bluesters: Weak indication
See it on the map
Open a Clovkamp spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Clovkamp loamy sand, 0 to 3 percent slopes, map unit 27A in Upper Deschutes River Area, Oregon, Parts of Deschutes, Jefferson, and Klamath Counties.
- Official Series Description: Clovkamp(revised 07/2003), established.
- Taxonomic class: Ashy over sandy or sandy-skeletal, glassy over mixed, mesic Vitritorrandic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.