Camas soil
Wild-clay potential
Weak indication
Weak indication: no layer of Camas shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Camas soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Camas gravelly sandy loam (Polk County, Oregon) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 3% clay.
- Lowers the potential Low engineering plasticity index (0): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 48 in (122 cm)).
- Note Typically starts within about 12 in (30 cm) of the surface.
- Lowers the potential High rock content (about 50% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A gravelly sandy loam layer about 0 to 12 in down: about 8% clay, low plasticity when wet, dark brown when moist. Weak indication
- Sandy layerH2best layer An extremely gravelly coarse sand layer about 12 to 60 in down: about 3% clay, low plasticity when wet, variegated extremely gravelly coarse sand mostly brown when moist. Weak indication
What it looks like raw
The sandy layer (H2), 12 to 60 in down in the typical profile: variegated extremely gravelly coarse sand mostly brown (10YR 4/3); loose. Raw colour is not fired colour.
About the soil
- Parent material: very gravelly alluvium.
- USDA family mineralogy: mixed.
- USDA family particle-size class: sandy-skeletal.
- Drainage: excessively drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Oregon, in these survey areas: Marion County Area, Oregon; Polk County, Oregon; Yamhill County, Oregon.
By state: wild clay in Oregon.
USDA, distribution and extent: Flood plains in western Oregon and Washington. The series is of moderate extent.
USDA, geographic setting: The Camas soils are on flood plains at elevations of 50 to 3,000 feet. Slopes range from 0 to 5 percent. The soils formed in gravelly and very gravelly coarse textured alluvium of mixed mineralogy. Winters are cool and moist and summers are warm and dry. The mean annual precipitation is 18 to 70 inches occurring mostly as rain in the fall, winter, and spring. The mean annual temperature is 48 to 55 degrees F. The mean July temperature is about 65 to 67 degrees F. and the mean January temperature is about 39 to 40 degrees F. The frost-free period is 150 to 235 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- McBee: Strong lead
- Bashaw: Strong lead
- Concord: Strong lead
- Dayton: Strong lead
- Holcomb: Strong lead
- Labish: Strong lead
- Wapato: Promising
- Chehalis: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 90%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Camas gravelly sandy loam, map unit 13 in Polk County, Oregon.
- Official Series Description: Camas(revised 07/2006), established.
- Taxonomic class: Sandy-skeletal, mixed, mesic Fluventic Haploxerolls
- Rated with rule version 2026-09-28.1; the method is on the About page.