Calvin soil
Wild-clay potential
Weak indication
Weak indication: no layer of Calvin shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Calvin soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Calvin shaly silt loam, 3 to 8 percent slopes (Schuylkill County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 23% clay. It may need settling or refining to become a clay body.
- Lowers the potential Low engineering plasticity index (6.5): little plastic behavior expected when wet.
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 18 in (46 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential High rock content (about 35% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Sandy layerH1 A channery silt loam layer about 0 to 8 in down: about 18% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH2best layer A very channery silt loam layer about 8 to 26 in down: about 23% clay, low plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerH3 An extremely channery silt loam layer about 26 to 40 in down: about 23% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- BedrockH4 Bedrock about 40 to 44 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (H2), 8 to 26 in down in the typical profile: reddish brown (5YR 4/4); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: red, residuum weathered from shale and siltstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 30 in (76 cm) down.
Where it is mapped
Seen on the map as the most common soil in 10 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Huntingdon County, Pennsylvania; Lehigh County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: MLRA 125, 126, 127, 128, 147 and 148. In Pennsylvania, West Virginia, Maryland and Virginia. The soils are of large extent.
USDA, geographic setting: Calvin soils formed in residuum of red non-calcareous shale, siltstone, and sandstone and are on summits, hillslopes and side slopes of ridges. Slope gradients range from 0 to 80 percent. Slopes range from 0 to 65 percent. Climate is humid continental. Mean annual air temperature ranges from 48 to 56 degrees F., mean annual precipitation ranges from 36 to 46 inches, frost free days range from 120 to 180 days, and elevation ranges from 400 feet to 3000 feet above sea level.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Edom: Strong lead
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Purdy: Strong lead
- Brinkerton: Promising
- Bowmansville: Promising
- Comly: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 80%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Calvin shaly silt loam, 3 to 8 percent slopes, map unit CaB in Schuylkill County, Pennsylvania.
- Official Series Description: Calvin(revised 05/2002), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.