Butlertown soil
Wild-clay potential
Possible
Possible: a clay-enriched layer typically about 16 to 29 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Butlertown soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Butlertown spot on the map
Rated from the USDA soil survey record for Butlertown-Urban land complex, 0 to 3 percent slopes (Delaware County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 18% clay. It may need settling or refining to become a clay body.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Note Moderate engineering plasticity index (12).
- Raises the potential The official series description calls the wet soil slightly sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 13 in (33 cm)).
- Note Typically starts within about 16 in (41 cm) of the surface.
- Note Few rock fragments (about 0% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 4 in down: about 12% clay, moderate plasticity when wet, dark grayish brown when moist. Weak indication
- Sandy layerE A silt loam layer about 4 to 10 in down: about 12% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Sandy layerBE A silt loam layer about 10 to 16 in down: about 15% clay, moderate plasticity when wet, light yellowish brown when moist. Weak indication
- Clay subsoilBtbest layer A silt loam layer about 16 to 29 in down: about 18% clay, moderate plasticity when wet, yellowish brown when moist. Possible
- Clay subsoilBtx A silt loam layer about 29 to 33 in down: about 19% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerBCx A loam layer about 33 to 48 in down: about 15% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layer2C A loamy fine sand layer about 48 to 80 in down: about 6% clay, moderate plasticity when wet, brownish yellow when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 16 to 29 in down in the typical profile: yellowish brown (10YR 5/4); friable, slightly sticky and plastic. Raw colour is not fired colour.
About the soil
- Parent material: silty eolian deposits over sandy or loamy fluviomarine deposits.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-silty.
- Drainage: moderately well drained.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Maryland, Pennsylvania, in these survey areas: Cecil County, Maryland; Delaware County, Pennsylvania.
By state: wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Distribution: Coastal plain of Maryland, Delaware, and New Jersey.
USDA, geographic setting: Landscape: Coastal plain
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Montalto: Strong lead
- Watchung: Strong lead
- Christiana: Strong lead
- Lenni: Strong lead
- Talleyville: Strong lead
- Baile: Promising
- Chrome: Promising
- Conowingo: Promising
See it on the map
Open a Butlertown spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 65%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Butlertown-Urban land complex, 0 to 3 percent slopes, map unit ByA in Delaware County, Pennsylvania.
- Official Series Description: Butlertown(revised 11/2015), established.
- Taxonomic class: Fine-silty, mixed, semiactive, mesic Typic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.