Conowingo soil
Wild-clay potential
Promising
Promising: a clay-enriched layer typically about 9 to 36 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Conowingo soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Conowingo spot on the map
Rated from the USDA soil survey record for Conowingo silt loam, 0 to 3 percent slopes (Chester County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clay-enriched layer: about 30% clay in the fine-earth portion.
- Note USDA labels this a "Bt" horizon: a subsoil layer where clay has accumulated.
- Raises the potential High engineering plasticity index (21.5): USDA's estimate suggests plastic behavior when wet.
- Raises the potential The official series description calls the wet soil moderately sticky and moderately plastic (a field observation, not a ceramic test).
- Note Thick enough to investigate (about 27 in (68 cm)).
- Note Typically starts within about 9 in (23 cm) of the surface.
- Note Few rock fragments (about 10% by volume).
Layer by layer
- TopsoilAp A silt loam layer about 0 to 9 in down: about 24% clay, moderate plasticity when wet, light olive brown when moist. Possible
- Clay subsoilBtbest layer A silty clay loam layer about 9 to 36 in down: about 30% clay, high plasticity when wet, yellowish brown when moist. Promising
- Loamy layerBC A clay loam layer about 36 to 60 in down: about 30% clay, high plasticity when wet, highly variegated strong brown when moist. Promising
- Loamy layerC A gravelly silt loam layer about 60 to 64 in down: about 24% clay, moderate plasticity when wet, strong brown when moist. Weak indication
What it looks like raw
The clay subsoil (Bt), 9 to 36 in down in the typical profile: yellowish brown (10YR 5/4); firm, sticky, plastic. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from serpentinite.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 65 in (165 cm) down.
Where it is mapped
Seen on the map as the most common soil in 5 map units in Maryland, Pennsylvania, in these survey areas: Cecil County, Maryland; Chester County, Pennsylvania; Delaware County, Pennsylvania.
By state: wild clay in Maryland,wild clay in Pennsylvania.
USDA, distribution and extent: Maryland and Pennsylvania. The series is not extensive.
USDA, geographic setting: Conowingo soils are nearly level to sloping soils in well dissected uplands of northern portions of the Piedmont Plateau. Slopes range from 0 to 15 percent. The soils formed in residuum from basic rocks high in magnesium, usually serpentine. The climate is temperate and humid with a mean annual temperature of 45 to 55 degrees F. and mean annual precipitation of 40 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Watchung: Strong lead
- Montalto: Strong lead
- Christiana: Strong lead
- Lenni: Strong lead
- Talleyville: Strong lead
- Baile: Promising
- Chrome: Promising
- Glenelg: Promising
See it on the map
Open a Conowingo spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 100%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Conowingo silt loam, 0 to 3 percent slopes, map unit CwA in Chester County, Pennsylvania.
- Official Series Description: Conowingo(revised 09/2008), established.
- Taxonomic class: Fine-loamy, magnesic, mesic Aquic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.