Bullock soil
Wild-clay potential
Weak indication
Weak indication: no layer of Bullock shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Bullock soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Bullock spot on the map
Rated from the USDA soil survey record for Bullock-Parchin fine sandy loams, 0 to 4 percent slopes (Meade County, South Dakota, Northern Part) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Bedrock or unweathered rock, not a soil layer to dig for clay.
Layer by layer
- Sandy layerH1 A fine sandy loam layer about 0 to 4 in down: about 8% clay, low plasticity when wet, grayish brown when moist. Weak indication
- Loamy layerH2 A sandy clay loam layer about 4 to 9 in down: about 27% clay, moderate plasticity when wet, grayish brown when moist. Weak indication
- Sandy layerH3 A sandy loam layer about 9 to 22 in down: about 15% clay, high plasticity when wet, light gray when moist. Weak indication
- BedrockCrbest layer Weathered bedrock about 22 to 60 in down: no clay layer to dig. Weak indication
What it looks like raw
The bedrock (Cr), 22 to 60 in down in the typical profile: light gray (2.5Y 6/1), gray (2.5Y 5/1) moist. Raw colour is not fired colour.
About the soil
- Parent material: residuum weathered from sandstone and/or shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Paralithic bedrock typically about 30 in (77 cm) down.
Where it is mapped
Seen on the map as the most common soil in 2 map units in South Dakota, in these survey areas: Meade County, South Dakota, Northern Part.
By state: wild clay in South Dakota.
USDA, distribution and extent: Northwestern South Dakota and possibly eastern Montana and southwestern North Dakota. This soil is extensive.
USDA, geographic setting: Bullock soils are on nearly level to steep uplands. Slope gradients range from 0 to 30 percent. The soils formed in residuum weathered from sandstone or silty and clayey shales interbedded with soft sandstone. Mean annual temperature ranges from 40 to 45 degrees F, and the mean annual precipitation ranges from l0 to l4 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Abor: Strong lead
- Absher: Strong lead
- Gerdrum: Strong lead
- Grail: Strong lead
- Heil: Strong lead
- Hisle: Strong lead
- Kyle: Strong lead
- Lawther: Strong lead
See it on the map
Open a Bullock spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 50%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Bullock-Parchin fine sandy loams, 0 to 4 percent slopes, map unit BpB in Meade County, South Dakota, Northern Part.
- Official Series Description: Bullock, established.
- Taxonomic class: Fine-loamy, mixed, superactive, frigid Aridic Leptic Natrustalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.