Buchanan soil
Wild-clay potential
Weak indication
Weak indication: no layer of Buchanan shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Buchanan soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Buchanan spot on the map
Rated from the USDA soil survey record for Buchanan channery loam, 3 to 8 percent slopes (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 22% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (15).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 21 in (53 cm)).
- Lowers the potential Typically starts about 50 in (128 cm) down, deeper than most hand digging.
- Lowers the potential High rock content (about 41% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- TopsoilAp A channery loam layer about 0 to 8 in down: about 19% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt1 A channery loam layer about 8 to 20 in down: about 25% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBt2 A channery loam layer about 20 to 29 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtx1 A channery loam layer about 29 to 35 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Clay subsoilBtx2 A channery loam layer about 35 to 50 in down: about 26% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerCbest layer A very channery loam layer about 50 to 71 in down: about 22% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- BedrockR Bedrock about 71 to 81 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (C), 50 to 71 in down in the typical profile: yellowish brown (10YR 5/6); very gravelly loam; firm, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: fine-loamy colluvium derived from sandstone and shale.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: moderately well drained.
- Lithic bedrock typically about 71 in (181 cm) down.
Where it is mapped
Seen on the map as the most common soil in 29 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Carbon County, Pennsylvania; Centre County, Pennsylvania; Huntingdon County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Northampton County, Pennsylvania; Schuylkill County, Pennsylvania; Venango County, Pennsylvania; Warren and Forest Counties, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Pennsylvania, New York, Virginia, West Virginia and Maryland. The series is of large extent.
USDA, geographic setting: Buchanan soils are on nearly level to very steep terraces and concave portions of mountain footslopes often extending well into the valleys along drainage ways. Slopes range from 0 to 45 percent. The Buchanan soils formed in colluvium derived from acid sandstone, quartzite, metarhyolite, siltstone and shale. Mean annual temperature ranges from 8 to 15 degrees C (47 to 59 degrees F); mean annual precipitation ranges from 97 to 117 cm (38 to 46 inches); and the growing season ranges from 140 to 170 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Cavode: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Armagh: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Millheim: Strong lead
See it on the map
Open a Buchanan spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
- Parts of the Official Series Description could not be interpreted; open the original for the complete text.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Buchanan channery loam, 3 to 8 percent slopes, map unit BuB in Centre County, Pennsylvania.
- Official Series Description: Buchanan(revised 08/2021), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Aquic Fragiudults
- Rated with rule version 2026-09-28.1; the method is on the About page.