Berks soil
Wild-clay potential
Weak indication
Weak indication: no layer of Berks shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Berks soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Berks and Weikert soils, 25 to 70 percent slopes (Centre County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Lowers the potential Too little clay to be a clay body on its own: about 13% clay.
- Lowers the potential Low engineering plasticity index (6): little plastic behavior expected when wet.
- Note Thick enough to investigate (about 15 in (37 cm)).
- Note Typically starts within about 22 in (57 cm) of the surface.
- Lowers the potential High rock content (about 72% by volume) lowers its practical promise; the clay percentage applies only to the fine earth between the rocks.
Layer by layer
- Organic top layerOi An organic top layer about 0 to 1 in down, not a clay body. Weak indication
- TopsoilA A channery silt loam layer about 1 to 5 in down: about 14% clay, moderate plasticity when wet, brown when moist. Weak indication
- Loamy layerBw1 A very channery loam layer about 5 to 15 in down: about 20% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Loamy layerBw2 A very channery silt loam layer about 15 to 22 in down: about 19% clay, moderate plasticity when wet, yellowish brown when moist. Weak indication
- Sandy layerCbest layer An extremely channery silt loam layer about 22 to 37 in down: about 13% clay, low plasticity when wet, yellowish brown when moist. Weak indication
- BedrockR Bedrock about 37 to 47 in down: no clay layer to dig. Weak indication
What it looks like raw
The sandy layer (C), 22 to 37 in down in the typical profile: yellowish brown (10YR 5/6); extremely channery loam; friable. Raw colour is not fired colour.
About the soil
- Parent material: acid brown residuum weathered from shale and siltstone and/or fine grained sandstone.
- USDA family mineralogy: mixed.
- USDA family particle-size class: loamy-skeletal.
- Drainage: well drained.
- Lithic bedrock typically about 37 in (94 cm) down.
Where it is mapped
Seen on the map as the most common soil in 40 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Carbon County, Pennsylvania; Centre County, Pennsylvania; Huntingdon County, Pennsylvania; Lebanon County, Pennsylvania; Lehigh County, Pennsylvania; Northampton County, Pennsylvania; Schuylkill County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Kentucky, Maryland, New Jersey, New York, Ohio, Pennsylvania, Virginia, West Virginia, Indiana, and Southern Illinois. MLRA's 115, 120, 121, 124, 125, 126, 127, 128, 130, 139, 147 and 148. The series is of large extent.
USDA, geographic setting: Berks soils are on summits, shoulders, and backslopes of dissected uplands formed in residuum weathered from shale interbedded with fine grained sandstone and siltstone. Slope gradient range from 0 to 80 percent. Climate is humid and temperate. Mean annual precipitation ranges from 40 to 44 inches, mean annual temperature ranges from 50 to 55 degrees F and the growing season is 170 to 214 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Hublersburg: Strong lead
- Opequon: Strong lead
- Dunning: Strong lead
- Edom: Strong lead
- Millheim: Strong lead
- Purdy: Strong lead
- Watchung: Strong lead
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 60%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Berks and Weikert soils, 25 to 70 percent slopes, map unit BMF in Centre County, Pennsylvania.
- Official Series Description: Berks(revised 09/1999), established.
- Taxonomic class: Loamy-skeletal, mixed, active, mesic Typic Dystrudepts
- Rated with rule version 2026-09-28.1; the method is on the About page.