Baltimore soil
Wild-clay potential
Promising
Promising: a clayey layer typically about 37 to 66 in below the surface.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Baltimore soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Open a Baltimore spot on the map
Rated from the USDA soil survey record for Baltimore gravelly loam, 3 to 8 percent slopes (Baltimore County, Maryland) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Raises the potential Clayey layer: about 42% clay in the fine-earth portion.
- Note Moderate engineering plasticity index (12).
- Note The official series description calls the wet soil slightly sticky.
- Note Thick enough to investigate (about 29 in (74 cm)).
- Note Typically starts about 37 in (94 cm) down; expect real digging or look for cuts and banks.
- Note Few rock fragments (about 8% by volume).
- Missing data Held at "Promising" because no plasticity evidence is available; a high clay percentage alone does not make a strong lead.
Layer by layer
- TopsoilAp, BE A gravelly loam layer about 0 to 18 in down: about 20% clay, moderate plasticity when wet, dark reddish brown when moist. Weak indication
- Clay subsoilBt A clay loam layer about 18 to 37 in down: about 30% clay, moderate plasticity when wet, red when moist. Promising
- Clay-rich layerBC,Cbest layer A clay layer about 37 to 66 in down: about 42% clay, moderate plasticity when wet, strong brown when moist. Promising
What it looks like raw
The clay-rich layer (BC,C), 37 to 66 in down in the typical profile: strong brown (7.5YR 5/6), reddish yellow (7.5YR 7/6) dry; very hard, firm, slightly sticky. Raw colour is not fired colour.
About the soil
- Parent material: loamy colluvium derived from mica schist over clayey residuum weathered from marble.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
Where it is mapped
Seen on the map as the most common soil in 3 map units in Maryland, in these survey areas: Baltimore County, Maryland.
By state: wild clay in Maryland.
USDA, distribution and extent: Maryland and possibly southeastern Pennsyl- vania and northern Virginia. The series is of small extent.
USDA, geographic setting: Baltimore soils occur in broad, shallow valleys in the northern part of the Piedmont Plateau. Slopes range up to 15 percent. The regolith is colluvial valley fill of weathered oligo- clase mica schist which rests unconformably on residuum from marble and/or dolomite. The climate is temperate and humid, with a mean annual air temperature of 50 to 55 degrees F. and mean annual precipi- tation of about 42 inches.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Benevola: Strong lead
- Christiana: Strong lead
- Cumberstone: Strong lead
- Jackland: Strong lead
- Montalto: Strong lead
- Watchung: Strong lead
- Baile: Promising
- Chillum: Promising
See it on the map
Open a Baltimore spot on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 85%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Baltimore gravelly loam, 3 to 8 percent slopes, map unit BcB in Baltimore County, Maryland.
- Official Series Description: Baltimore(revised 01/2006), established.
- Taxonomic class: Fine-loamy, mixed, semiactive, mesic Typic Hapludolls
- Rated with rule version 2026-09-28.1; the method is on the About page.