Athol soil
Wild-clay potential
Weak indication
Weak indication: no layer of Athol shows strong clay evidence in the USDA data.
A level means "worth investigating". It never confirms usable pottery clay.
This page is about Athol soil in general. Whether it lies under a particular spot, and how deep its clay layer sits there, depends on the spot: tap it on the free Wild Clay Archive map at wildclayarchive.com.
Rated from the USDA soil survey record for Athol silt loam, 3 to 8 percent slopes (Berks County, Pennsylvania) and the Official Series Description. Depths are typical for the series, not measured at any spot.
Why this level
- Note Loamy layer with some clay: about 25% clay. It may need settling or refining to become a clay body.
- Note Moderate engineering plasticity index (17).
- Note The official series description calls the wet soil slightly sticky and slightly plastic.
- Note Thick enough to investigate (about 33 in (84 cm)).
- Note Typically starts within about 8 in (20 cm) of the surface.
- Lowers the potential Noticeable rock fragments (about 15% by volume); screening would be needed and the clay percentage applies to the fine earth only.
Layer by layer
- TopsoilA1 A silt loam layer about 0 to 8 in down: about 19% clay, moderate plasticity when wet, dark brown when moist. Weak indication
- Loamy layerB2best layer A gravelly silt loam layer about 8 to 41 in down: about 25% clay, moderate plasticity when wet, reddish brown when moist. Weak indication
- Loamy layerC3 A gravelly loam layer about 41 to 62 in down: about 25% clay, moderate plasticity when wet, weak red when moist. Weak indication
- BedrockR4 Bedrock about 62 to 66 in down: no clay layer to dig. Weak indication
What it looks like raw
The loamy layer (B2), 8 to 41 in down in the typical profile: reddish brown (2.5YR 4/4); friable, slightly sticky, slightly plastic. Raw colour is not fired colour.
About the soil
- Parent material: red fine-loamy residuum weathered from calcareous conglomerate.
- USDA family mineralogy: mixed.
- USDA family particle-size class: fine-loamy.
- Drainage: well drained.
- Lithic bedrock typically about 62 in (157 cm) down.
Where it is mapped
Seen on the map as the most common soil in 7 map units in Pennsylvania, in these survey areas: Berks County, Pennsylvania; Montgomery County, Pennsylvania.
By state: wild clay in Pennsylvania.
USDA, distribution and extent: Southeastern Pennsylvania, central Maryland, New Jersey and northern Virginia. The series is of moderate extent.
USDA, geographic setting: Athol soils are on nearly level to moderately steep convex and disected upland ridge tops and side slopes. Slopes range from 0 to 35 percent. They formed in residuum weathered from Triassic conglomerate or breccia consisting of a red calcareous matrix containing fragments of limestone, shale, sandstone and quartz. Climate is humid and temperate, with mean annual precipitation of 40 to 44 inches; average annual temperature is 52 to 55 degrees F and the growing season is 170 to 200 days.
Other soils near it
Rated soils mapped in the same counties, stronger leads first.
- Hagerstown: Strong lead
- Watchung: Strong lead
- Bowmansville: Promising
- Croton: Promising
- Duffield: Promising
- Mount Lucas: Promising
- Raritan: Promising
- Readington: Promising
See it on the map
Soil information does not grant access or permission to dig. Verify ownership, local rules, and permission before visiting or collecting.
Important uncertainties
- A component percentage (about 91%) estimates how much of the whole map unit this component covers; it is not the chance that it lies under a spot you look up on the map.
- Layer depths and thicknesses are typical values for the series; the actual profile at a spot can differ substantially.
- Clay percentages describe the fine-earth fraction (particles under 2 mm); rock fragments are reported separately.
- USDA words like "sticky" and "plastic" are field observations on wet soil, not tests of forming, drying, or firing behavior.
Sources
- USDA Soil Data Access (SSURGO): the survey record for Athol silt loam, 3 to 8 percent slopes, map unit AsB in Berks County, Pennsylvania.
- Official Series Description: Athol(revised 09/2008), established.
- Taxonomic class: Fine-loamy, mixed, active, mesic Ultic Hapludalfs
- Rated with rule version 2026-09-28.1; the method is on the About page.